Portable and Mobile Radio RFI Solutions
Portable operation is fun but also brings challenges to the radio operator concerning receiver “noise” levels, RF interference from adjacent sources including close by transmitting stations, and RFI from portable generators. A typical scenario and some suggested Palomar product solutions are shown in the picture.
Portable operation is typical of ham radio operating events such as Field Day, Summits on the Air, Route 66 events, National Parks on the Air, California QSO party, DXpeditions, and emergency operation command posts, etc.
Suggestions
Each low power operating station with a generator should have:
- Generator RFI Kit (Part # RFI-GEN) with FSB31-1 ferrite filters at each end + Nylon ties for security
- Transceiver RFI Kit (Part # RFI-XCVR)
- Laptop RFI Kit (Part # RFI-1C)
- Coax Cable Noise Filter (Part # CMNF-1)
- Bullet-55 portable HF end fed antenna system





We specify impedance ratios as an output to input ratio where the output (or load) is given first and the input is given second (e.g. 100:50 (2:1) would mean a 100 ohm output and a 50 ohm input; a 25:50 (1:2) would mean a 25 ohm load and a 50 ohm input). Most all products use a 50 ohm input unless otherwise specified.
We have products that are available as kits for the do-it-yourself (DIY) person or fully assembled and tested units for the “Plug & Play” crowd.
Our impedance transformers are available using two different topologies: Binocular cores or toroid cores with multiple turns for increased effectiveness and wide band frequency transformations. We utilize single and multiple core transformers using high order windings when needed to extend product performance.
We rate the power ratings as watts PEP (Peak Envelop Power) with standard duty cycles for various modes. To determine the PEP rating required for your needs, see: Choke & Transformer Power Ratings
This website page serves as a link page to the frequency ranges of our impedance transformers configured as either baluns or ununs. You can click on a picture to go to the specific page about the products described in the picture.