16:1 Baluns/Ununs

Get The BEST - Get Palomar!


YOUR ONE STOP SHOP FOR RFI SOLUTIONS AND ANTENNA PRODUCTS TO BOOST YOUR SIGNAL

📚 FREE Helpful Technical Guides — Download Knowledge you can put on the air!

Learn how to select, configure and use our products to improve your station


HF WIRE ANTENNAS
OVER 10,000 Installed worldwide!

BULLET End Fed Antennas
Shorter, safer, more bands in less space than EFHW
Off Center Fed Dipoles
Traditional dipole style but cut for more bands then other vendors!
End Fed OCF
160-6M, 80-6M, 40-6M or 20-6M but only 2 supports, shorter than EFHW - popular with POTA ops
Full Wave Loop
Quieter on receive and multi-directional gain on higher bands, no need to rotate!

ZS6BKW Multi-band Ladder Line Fed
No tune on 5 bands!

Broadband Terminated Dipoles (BBTD, T2FD)
DIY Parts for ALE, MARS, Hi duty cycle data modes


ANTENNA ACCESSORIES
Coax Common Mode Chokes - Slip On, Snap On, Jumper, Mini/Maxi-Choker/Line Isolator, DIY Ferrite Choke Kits

Noise Filters
- Coax, AC/DC Power 100 KHz - 150 MHz, up to -48 dB noise suppression - hear DX again!

Baluns & Ununs (1:1-81:1 ratios) for RX, 100/500/1500/5000 Watts including Hybrids (with choke) and Multi-Ratio

RFI SOLUTIONS

OUR RFI STRATEGY: FIND IT - FIX IT - FORGET IT!

RF Detectors - SIGNALPEN(TM) PENCIL SIZE RF Detector, 60 Hz to 5 GHz, Miliwatts to Kilowatts, Direct Contact or Inductive Detector, No Battery & Fits in Your Shirt Pocket!

RFI Solutions - Consumer Electronics, Ham Radio, Computer, Audio/Home Theater, Wall Warts, Solar and more!

Ferrite Products- Rings, Snap On, Slip On, useful from 150KHz - 2 GHZ, Mixes 31, 43, 52, 61, 75, 77

Radio Transceiver/Linear Amplifier RFI Kits - All Brands, VLF to UHF, QRP to Multi-KW

FREE USPS Ground SHIPPING to USA Destinations for orders over $100!


SELECT A CATEGORY TO EXPLORE


Filters

Filters
16:1 Baluns are useful between 750-850 ohm balanced loads where the impedance at the  end of the feed line is 800 ohms (1/2 wavelength feed line), or high impedance feeds for rhombic,  T2FD and traveling wave antennas.

16:1 Ununs are useful between coax and long wires with a load impedance near 800 ohms like a beverage antenna.  Shortwave listener antennas also can benefit with the 16:1 unun and it may provide a better match than 9:1 ununs – this means quieter noise levels and stronger signals so you can hear distance stations easier.