Impedance Transformers (<1:1, >1:1)

BF2023 banner png - Impedance Transformers (<1:1, >1:1)


BULLET-2006 Antenna (Click for more info)

BULLET 2006 Configuration png - Impedance Transformers (<1:1, >1:1)

BULLET-4006 Antenna (Click for more info)

BULLET4046 Antenna System  png - Impedance Transformers (<1:1, >1:1)

BULLET-8006 Antenna

BULLET 8006 Configuration 09272023 png - Impedance Transformers (<1:1, >1:1)

Palomar Engineers Antenna Info Sheet

Popular Categories

HF Wire Antennas - End Feds, Off Center Fed, Loop, T2FD/BBTD, Dipoles and Zepps, 160-6 Meters, Wire, Hardware and Instructions for you.

Ferrite Products - Rings, Snap On, Slip On, useful from 150KHz - 2 GHZ, Mixs 31, 43, 52, 61, 75

RFI Solutions - Consumer Electronics, Computer, Audio/Home Theater, Wall Warts, Solar and more!

Baluns/Ununs/Chokes (1:1-81:1 ratios) for RX, 100/500/1500/5000 Watts including Hybrids (with choke) and Multi-Ratio

Radio Transceiver/Linear Amplifier RFI Kits - All Brands, VLF, HF to UHF

Noise Filters - Coax, AC and DC power 100 KHz - 150 MHz, up to -48 dB noise suppression - hear DX again!

Palomar Engineers® products are over engineered to outperform the competition without being over priced!

Buy DIRECT, on eBay or at Ham Radio Outlet stores nationwide, HRO Product List HERE

QUICK and EASY RFI Solutions for Consumer Electronics - FREE RFI Tip Sheet

All Palomar manufactured items made in USA!

Featured Products

On Sale
2833412803 - Impedance Transformers (<1:1, >1:1)
Garage Door Opener RFI Kit
Garage Door Opener RFI Kit
List price $49.95
Save 20%
Palomar Engineers offers a variety of impedance transformers configured as Baluns (balanced coax to unbalanced load) or Ununs (unbalanced coax to unbalanced load) for  matching typical 50 ohm feed line impedances to antenna or other load impedances.

We specify impedance ratios as an output to input ratio where the output (or load) is given first and the input is given second (e.g. 100:50 (2:1) would mean a 100 ohm output and a 50 ohm input; a 25:50 (1:2) would mean a 25 ohm load and a 50 ohm input).  Most all products use a 50 ohm input unless otherwise specified.

We have products that are available as kits for the do-it-yourself (DIY) person or fully assembled and tested units for the “Plug & Play” crowd.

Our impedance transformers are available using two different topologies: Binocular cores or  toroid cores with multiple turns for increased effectiveness and wide band frequency transformations.  We utilize single and multiple core transformers using high order windings when needed to extend product performance.

We rate the power ratings as watts PEP (Peak Envelop Power) with standard duty cycles for various modes. To determine the PEP rating required for your needs, see: Choke & Transformer Power Ratings

This website page serves as a link page to the frequency ranges of our impedance transformers configured as either baluns or ununs.  You can click on a picture to go to the specific page about the products described in the picture.