The RFI generator kit includes 2 ring filters with 3 inch inside diameter for 2 or more turns of AC/DC generator cable at generator and another 2 or more turns through center at the end of the generator cable near the powered device. The filter near the generator isolates generator power cable and prevents it from acting as an RFI antenna (generator source) and the filter near the powered device prevents the powered device from using the generator cable as an RFI antenna.
Use 2 or more turns through the filter for higher RFI suppression than a single turn (2 turns is 4 times the suppression as 1 turn, 3 turns is 9 times a single turn, etc.)
If you have a generator cable less than 1/2" diameter, consider the RFI-GEN-1 generator filter with a 1" inside diameter.
Note: generator cable not included.
We specify impedance ratios as an output to input ratio where the output (or load) is given first and the input is given second (e.g. 100:50 (2:1) would mean a 100 ohm output and a 50 ohm input; a 25:50 (1:2) would mean a 25 ohm load and a 50 ohm input). Most all products use a 50 ohm input unless otherwise specified.
We have products that are available as kits for the do-it-yourself (DIY) person or fully assembled and tested units for the “Plug & Play” crowd.
Our impedance transformers are available using two different topologies: Binocular cores or toroid cores with multiple turns for increased effectiveness and wide band frequency transformations. We utilize single and multiple core transformers using high order windings when needed to extend product performance.
We rate the power ratings as watts PEP (Peak Envelop Power) with standard duty cycles for various modes. To determine the PEP rating required for your needs, see: Choke & Transformer Power Ratings
This website page serves as a link page to the frequency ranges of our impedance transformers configured as either baluns or ununs. You can click on a picture to go to the specific page about the products described in the picture.