A simple ferrite ring filter (OD = 1.14", ID = .748") installed on the DC power cable of a wall wart power supply can help suppress the noise interference to nearby electronic devices by suppressing the fundamental switching frequency (usually under 1 MHz) and thereby suppressing harmonics at higher frequencies. This kit includes 10 filters useful for all types of devices powered by wall wart power supplies including laptop computer, routers, cable modems, wireless phone charges, USB chargers, etc.
We specify impedance ratios as an output to input ratio where the output (or load) is given first and the input is given second (e.g. 100:50 (2:1) would mean a 100 ohm output and a 50 ohm input; a 25:50 (1:2) would mean a 25 ohm load and a 50 ohm input). Most all products use a 50 ohm input unless otherwise specified.
We have products that are available as kits for the do-it-yourself (DIY) person or fully assembled and tested units for the “Plug & Play” crowd.
Our impedance transformers are available using two different topologies: Binocular cores or toroid cores with multiple turns for increased effectiveness and wide band frequency transformations. We utilize single and multiple core transformers using high order windings when needed to extend product performance.
We rate the power ratings as watts PEP (Peak Envelop Power) with standard duty cycles for various modes. To determine the PEP rating required for your needs, see: Choke & Transformer Power Ratings
This website page serves as a link page to the frequency ranges of our impedance transformers configured as either baluns or ununs. You can click on a picture to go to the specific page about the products described in the picture.