The Ferrite Snap On Combo Pack is a convenient solution for troubleshooting RFI/EMI with various diameter cables ranging from 1/4″ to 3/4″ for use as either single turn or multiple turn ferrite chokes. The snap on chokes are useful for RF coax, AC/DC power cables, and device interconnection cables.
Always use a snap on with a larger inside diameter than the diameter of the cable and use multiple turns if possible (2 turns through the snap on is the same as 4 snap ons with 1 turns). Included in these combo packs are our most popular snap on sizes as follows:
Portable and Mobile Radio RFI Solutions
Portable operation is fun but also brings challenges to the radio operator concerning receiver “noise” levels, RF interference from adjacent sources including close by transmitting stations, and RFI from portable generators. A typical scenario and some suggested Palomar product solutions are shown in the picture.
Portable operation is typical of ham radio operating events such as Field Day, Summits on the Air, Route 66 events, National Parks on the Air, California QSO party, DXpeditions, and emergency operation command posts, etc.
Suggestions
Each low power operating station with a generator should have:
- Generator RFI Kit (Part # RFI-GEN) with FSB31-1 ferrite filters at each end + Nylon ties for security
- Transceiver RFI Kit (Part # RFI-XCVR)
- Laptop RFI Kit (Part # RFI-1C)
- Coax Cable Noise Filter (Part # CMNF-1)
- Bullet-55 portable HF end fed antenna system
