The Ferrite Snap On Combo Pack is a convenient solution for troubleshooting RFI/EMI with various diameter cables ranging from 1/4″ to 3/4″ for use as either single turn or multiple turn ferrite chokes. The snap on chokes are useful for RF coax, AC/DC power cables, and device interconnection cables.
Always use a snap on with a larger inside diameter than the diameter of the cable and use multiple turns if possible (2 turns through the snap on is the same as 4 snap ons with 1 turns). Included in these combo packs are our most popular snap on sizes as follows:
All Snap On Split Beads
Often it is difficult to slip beads on a cable because of a plug or connector. Split beads solve this problem. They come in two halves that fit over the cable. A plastic snap cover holds the two halves together and holds the assembly on the cable.
For RFI use, mix 31 is effective from 1-300 MHz, mix 43 works from 25-300 MHz, Mix 61 is for 200-2000 MHz, and mix 75 favors .15-10 MHz. These frequencies are those of the interfering signal to be eliminated, not the operating frequencies of the equipment to be protected.
Not sure of what sizes you need or solving a RFI problem with devices using multiple size cables? Try the Ferrite Snap On Combo Pack which has sizes from 1/4″ to 3/4″ with either Mix 31 (1-300 MHz) or Mix 61 (200-2000 MHz) or Mix 75 (100 KHz – 10 MHz).
SNAP ON Sizes for Heliax and Coax Cable
Shown below in the table are the SLIP ON and SNAP ON products for various popular Heliax and Coax cables. These are the correct size for making sleeve chokes – See above table for technical details.
