Noise Filters - AC/DC
Our noise filters are designed to suppress common mode noise on AC/DC power lines, Switching Mode Power Supply (SMPS) input/output, and computer/instrumentation power input/output/control lines. Also suitable for PLC control line noise suppression (use mix 77/75 ferrite filters).
Refine by
On Sale
DC Voltage Common Mode Noise Filter - Marine, RV, Communications, 600 Volts/30 Amps
DC Voltage Common Mode Noise Filter - Marine, RV, Communications, 600 Volts/30 Amps
SKU RFI-DC-30
List price
$109.95
Save 18%
$89.95
On Sale
FT240-3I, ID=1.4", AC/DC/Coax Noise Filter, RFI Range 1-300 MHz, Bulk Pack of 10
FT240-3I, ID=1.4", AC/DC/Coax Noise Filter, RFI Range 1-300 MHz, Bulk Pack of 10
SKU F240-31-10
List price
$100.00
Save 10%
$89.95
On Sale
FT240-3I, ID=1.4", AC/DC/Coax Noise Filter, RFI Range 1-300 MHz, Mini Pack of 3
FT240-3I, ID=1.4", AC/DC/Coax Noise Filter, RFI Range 1-300 MHz, Mini Pack of 3
SKU F240-31-3
List price
$34.95
Save 14%
$29.95
FT240-61, ID=1.4", RFI Range 200-2000 MHz
FT240-61, ID=1.4", RFI Range 200-2000 MHz
SKU F240-61-1
$16.95
16:1 Baluns are useful between 750-850 ohm balanced loads where the impedance at the end of the feed line is 800 ohms (1/2 wavelength feed line), or high impedance feeds for rhombic, T2FD and traveling wave antennas.
16:1 Ununs are useful between coax and long wires with a load impedance near 800 ohms like a beverage antenna. Shortwave listener antennas also can benefit with the 16:1 unun and it may provide a better match than 9:1 ununs – this means quieter noise levels and stronger signals so you can hear distance stations easier.