16:1 Baluns/Ununs

1725564652 - 16:1 Baluns/Ununs
+3

DC-AC Inverter Common Mode RFI/Noise Filter Kit for DC in and AC Output

RFI-INVERTER
$34.95
In stock
1
Product Details
MPN: RFI-INVERTER
Type: NEW
Country/Region of Manufacture: United States
Filter Power Rating (PEP watts): n/a
RFI Suppression Range (MHz): 150 KHz - 10 MHz
Typical Use:: DC-AC switch mode inverters common mode noise suppression

The RFI-INVERTER is a common mode noise filter set which filters both the DC input and AC output of DC-AC inverters. These filters effectively isolate the DC power cord and AC output cable from acting as antennas for the internal switching power supply. The filters suppress RFI from 150 KHz to 10 MHz. Simple to install on cables without any device modification. DC filter is a ring and AC output filter is a snap on with 1" inside diameter hole.

For larger cables use the ACCF-3 and DCCF-3 ring filters with 3" inside diameters and use multiple turns on each cable for best results.

AC power strip shown in picture NOT INCLUDED - this is user supplied and shown for illustration of filter installation.



Save this product for later
Display prices in: USD
16:1 Baluns are useful between 750-850 ohm balanced loads where the impedance at the  end of the feed line is 800 ohms (1/2 wavelength feed line), or high impedance feeds for rhombic,  T2FD and traveling wave antennas.

16:1 Ununs are useful between coax and long wires with a load impedance near 800 ohms like a beverage antenna.  Shortwave listener antennas also can benefit with the 16:1 unun and it may provide a better match than 9:1 ununs – this means quieter noise levels and stronger signals so you can hear distance stations easier.