16:1 Baluns/Ununs

2654143997 - 16:1 Baluns/Ununs
+3

DC Cable Noise Filter for 2 Gauge and Smaller Wire - 1.4" ID

DCCF-1.4
$12.95
In stock
1
Product Details
MPN: ACCF-3
Type: New
Country/Region of Manufacture: United States
RFI Range (MHz): 150 KHz to 10 MHz
ID-B (in/mm): 1.4/35.6
OD-A (in/mm): 2.4/61
Height-C (in/mm): 5/12.7
Weight (oz/gm): 106 grams
Initial permeability: 5000

(2.4″ OD, 1.4″ ID hole), RFI Noise Suppression Range: 150 KHz-10 MHz, Mix 75

Excellent for large cables or multiple cables – use multiple cores for higher choking. Also useful when you need high turns count for high choking with large cable - works on large gauge DC power cables.

Note: put both positive and negative cables TOGETHER through the filter so that their differential currents cancel but their common mode currentsare suppressed.
Save this product for later
Display prices in: USD
16:1 Baluns are useful between 750-850 ohm balanced loads where the impedance at the  end of the feed line is 800 ohms (1/2 wavelength feed line), or high impedance feeds for rhombic,  T2FD and traveling wave antennas.

16:1 Ununs are useful between coax and long wires with a load impedance near 800 ohms like a beverage antenna.  Shortwave listener antennas also can benefit with the 16:1 unun and it may provide a better match than 9:1 ununs – this means quieter noise levels and stronger signals so you can hear distance stations easier.