The PAL-OCF4010 covers 40-30-20-17-15-12-10 and 6 meters in a length of 66 feet. In most cases, no antenna tuner is needed and switching bands is as easy as changing the band on the radio. Super convenient and quick – great for contest operation! Choose 500, 1500 or 5000 watts PEP power levels.
Uses hybrid balun containing wide band 4:1 transformer + 1:1 common mode feed line choke to keep all your power on the antenna and off the feed line coax outer conductor!
Unlike Buckmaster OCF antennas (at twice the price, and no WARC band or 15 Meter operation), you can transmit and receive on 6, 12, 15 and 17 meters with our OCF - Better engineering and lower price - only from Palomar Engineers!
Also much quieter than end fed half wave antennas!
INSTALLATION
For best results support balun at 30+ feet and ends over 15 feet. Angle of feed each side must be great than 45 degrees or 120 – 180 degrees total between each side preferred. Any length of 50 ohm feed line ok but longer feed lines over 50 feet may show reduced SWR on some bands due to losses in feed line and soil conductivity, nearby objects, etc. Due to local ground conditions, antenna height and feed line length, SWR may vary from samples shown and an internal or external antenna tuner may be required or some bands to bring SWR at end of feed line to acceptable levels. Overall length is 66 feet (11 feet and 55 feet sides).
FREE USA Shipping on orders over $100
NEED and END FED antenna covering the same bands and only requiring two supports rather than three? Check out the BULLET-4006
SLIP-ON FERRITE BEADS
Baluns are used to connect balanced antennas to unbalanced transmission lines (Coaxial cable) and Ununs are used to connect unbalanced transmission lines to unbalanced transmission lines or unbalanced antennas (e.g. verticals). In the case of 1:1 baluns the input is usually an unbalanced coax cable and the output load is a two terminal balanced load like an antenna. Ununs are also called line isolators, feed line chokes, and 1:1 coaxial baluns (incorrectly). 1:1 Baluns and ununs stop common mode currents (flowing on the outside of the coax braid due to skin effect) when they are located at the antenna feedpoint. They can also be used as “line isolators/chokes” anywhere along the cable to suppress flow of induced RF (antenna near field radiation and neighborhood noise pickup) which helps suppress RFI into the radio receiver/transmitter. For best results, put one at the antenna feed point connection, and one at the radio room entrance, and for difficult common mode current cases, one every 1/4 wavelength along the antenna feed line. For low (below 3 MHz) frequencies, use two 5 bead baluns in series to double the choking impedance or order the 10 bead or 15 bead version for higher choking power.