MAXI-CHOKER Coax Line Isolator/Balun, 1-61 MHz, 1.5/3KW, SO-239 In/Stud Output, FLAGPOLE OCF, G5RV, ZS6BKW, BN4000 Replacement, Ladder Line-Coax interface
MAXI-CHOKER Features:
- Uses proprietary Multi-Mix(TM) technology for maximum choking (up to 5K ohm) and maximum bandwidth
- 1.5 KW or 3 KW PEP Option, 50 ohm SO-239 connectors In dual screw terminal output for ladder line or dipole driven element, etc. effective 1-61 MHz
- Up to -48dB common mode suppression solves tough RFI issues
- Works for all coax fed antennas from 1.8-61 MHz (160-6 meters) - excellent for multi-band beams, verticals, dipoles, off center fed antennas, tri-band beams.
- 2-5 times more choking resistance, wider bandwidth and higher power then competing filters
- great replacement choke for G5RV/ZS6BKW antennas or as a 1:1 ladder line to coax interface for Flagpole OCF type antennas with high common mode choking to isolate the coax braid from becoming part of the antenna.
- Available with ground lug/internal static bleeder option
- Excellent replacement for Hygain BN4000D balun used on beam antennas
MAXI-CHOKER feed line chokes are used to suppress common mode current carried on the outside of the coax braid which is often responsible for receiver noise and RFI in the receiver/transmitter. These chokes are very useful for suppressing RFI common mode current at the antenna feed point or at a ladder line to coax junction, like a G5RV antenna.
Note: Color may be white or black depending on on inventory at time of order. Also available with SO-239 in/Out (MC-1-1500 or MC-1-3000) or with static bleeder/ground (MC-1-1500GB or MC-1-3000GB).
SLIP-ON FERRITE BEADS
Baluns are used to connect balanced antennas to unbalanced transmission lines (Coaxial cable) and Ununs are used to connect unbalanced transmission lines to unbalanced transmission lines or unbalanced antennas (e.g. verticals). In the case of 1:1 baluns the input is usually an unbalanced coax cable and the output load is a two terminal balanced load like an antenna. Ununs are also called line isolators, feed line chokes, and 1:1 coaxial baluns (incorrectly). 1:1 Baluns and ununs stop common mode currents (flowing on the outside of the coax braid due to skin effect) when they are located at the antenna feedpoint. They can also be used as “line isolators/chokes” anywhere along the cable to suppress flow of induced RF (antenna near field radiation and neighborhood noise pickup) which helps suppress RFI into the radio receiver/transmitter. For best results, put one at the antenna feed point connection, and one at the radio room entrance, and for difficult common mode current cases, one every 1/4 wavelength along the antenna feed line. For low (below 3 MHz) frequencies, use two 5 bead baluns in series to double the choking impedance or order the 10 bead or 15 bead version for higher choking power.