CUBE 1:1 Balun, 5KW, 160-6 Meters, -38dB CMRR, FT8/RTTY
| Quantity | Price per item | Discount |
| 2 items | $139.95 | 7% off |
| 10 items | $129.95 | 13% off |
5000 Watt Rated 1:1 CUBE™ BALUN
* Suppress radiation from coax cable
* Provides maximum transfer of RF to the antenna.
* Help keep RF out of the shack.
* Heavy Duty Cycle for Legal Limit FT8/RTTY
* Reduces RFI to appliances and neighbors.
* Side Eye Bolts or Top Studs Output Option
This BALUN utilizes mil-spec coax cable for the windings on multiple ferrite beads with coax silver shield and silver braid for low loss. The dielectric is Teflon® insulation for high voltage ratings of 1,900 volts. (A typical 5KW signal at 50 ohms impedance will have a voltage of 500 volts at 1:1 SWR). Available wired as a BALUN (CB-1-5000) with wire studs output or side eye bolts for dipole antennas. Rated 5KW PEP/1500 Watts AM/RTTY/CW/FT-8 from 1.8-61 MHz. Enclosure is 4" x 4" x 2"
If you run FT8/RTTY contests at 1500 watts output, this is the balun you need – it won’t burn out at heavy 1500 watt duty cycles like other brands rated at 1500 watts (or more). We use these same chokes in our own RTTY station at full 1500 watts output and they have never failed. We use one at the amplifier output and another at each antenna feed point. Works very well on OCF antennas below the 4:1 balun to keep RF current on the antenna and off the feed line. Built like a tank, works like a charm, and priced under the competition – what more can you ask for? THIS IS OUR MOST POPULAR 1:1 BALUN!
SLIP-ON FERRITE BEADS
Baluns are used to connect balanced antennas to unbalanced transmission lines (Coaxial cable) and Ununs are used to connect unbalanced transmission lines to unbalanced transmission lines or unbalanced antennas (e.g. verticals). In the case of 1:1 baluns the input is usually an unbalanced coax cable and the output load is a two terminal balanced load like an antenna. Ununs are also called line isolators, feed line chokes, and 1:1 coaxial baluns (incorrectly). 1:1 Baluns and ununs stop common mode currents (flowing on the outside of the coax braid due to skin effect) when they are located at the antenna feedpoint. They can also be used as “line isolators/chokes” anywhere along the cable to suppress flow of induced RF (antenna near field radiation and neighborhood noise pickup) which helps suppress RFI into the radio receiver/transmitter. For best results, put one at the antenna feed point connection, and one at the radio room entrance, and for difficult common mode current cases, one every 1/4 wavelength along the antenna feed line. For low (below 3 MHz) frequencies, use two 5 bead baluns in series to double the choking impedance or order the 10 bead or 15 bead version for higher choking power.