Portable Operation RFI Kits

Off Center Fed Dipole Antenna, 40-6 Meters, 500/1.5KW/5KW PEP rated - FREE shipping in USA

SKU PAL-OCF4010-500
$149.95
On Sale
$279.95 Save 46%
PEP Power Rating
1
Save this product for later
Share this product with your friends
Off Center Fed Dipole Antenna, 40-6 Meters, 500/1.5KW/5KW PEP rated - FREE shipping in USA
Product Details
Brand: Palomar Engineers
Freq Range (MHz):: 7-54 Mhz
Power (PEP watts):: 500/1500/5000 watts digital
Length (ft):: 55 + 12 FEET

The PAL-OCF4010 covers 40-30-20-17-15-12-10 and 6 meters in a length of 66 feet. In most cases, no antenna tuner is needed and switching bands is as easy as changing the band on the radio. Super convenient and quick – great for contest operation! Choose 500, 1500 or 5000 watts PEP power levels.

Uses hybrid balun containing wide band 4:1 transformer + 1:1 common mode feed line choke to keep all your power on the antenna and off the feed line coax outer conductor!

Unlike Buckmaster OCF antennas (at twice the price, and no WARC band or 15 Meter operation), you can transmit and receive on 6, 12, 15 and 17 meters with our OCF - Better engineering and lower price - only from Palomar Engineers!

Also much quieter than end fed antennas!

INSTALLATION

For best results support balun at 30+ feet and ends over 15 feet. Angle of feed each side must be great than 45 degrees or 120 – 180 degrees total between each side preferred. Any length of 50 ohm feed line ok but longer feed lines over 50 feet may show reduced SWR on some bands due to losses in feed line and soil conductivity, nearby objects, etc. Due to local ground conditions, antenna height and feed line length, SWR may vary from samples shown and an internal or external antenna tuner may be required or some bands to bring SWR at end of feed line to acceptable levels. Overall length is 66 feet (11 feet and 55 feet sides).

FREE USA Shipping on orders over $100

NEED and END FED antenna covering the same bands and only requiring two supports rather than three? Check out the BULLET-4006


Portable operation is fun but also brings challenges to the radio operator concerning receiver “noise” levels, RF interference from adjacent sources including close by transmitting stations, and RFI from portable generators.  A typical scenario and some suggested Palomar product solutions are shown in the picture below:

Generator RFI testimonial:

Bob 

Received your order in a timely fashion. Tried the generator kit on Sunday & it drops the noise from S9 to S5 and 
took out all the electrical noise.  I may want some more toroids from you at some point for other interference problems
I have  here.
Ken VE3KCY

Using an amplifier?  Don’t forget our Linear Amplifier RFI Kits

Want to make up your own RFI kits for a particular operation? Here are links to some of  typical RFI solutions used in portable operations:

AC/DC common mode filters

Feed Line chokes

Coax Noise Filters

If you use a computer for logging in your portable operations, RFI getting into computers will often lock up your computer and/or radio and a computer RFI suppression kits may be helpful

Computer RFI Kits

Make your expedition or portable operation a pleasant and fun outing and remember to take along your RFI kits so you have more time to operate rather then to troubleshoot intermittent or noisy receiver conditions.

Portable Antenna Kits

If you need an effective portable antenna which folds up for transport yet is easy to deploy at your operating site, consider the BULLET series of end fed wire antennas.

BULLET Antennas (click on link or picture for more info)

Bullet Antenna Product 300x292 - Portable Operation RFI Kits