After many requests we have created a compact, special balun for single band loop (Sky loop or Delta loop) antennas with specific dimension that present a feedpoint of 70-75 ohms. The CB-1.5-1-1500/5000 is a CUBE(TM) enclosure containing a multi-core, broadband 1.5:1 impedance transformer (50 ohm coax input to 75 ohm balanced output) in series with a 1:1 current balun for extra common mode current choking to keep RF current off the outside of the coax braid and on the antenna where it belongs. The extra choking action also means that the coax feed line will not act as a radiator causing unnecessary RF interference (RFI). Rated for full 1500 watts PEP and 1500 watts CW (ICAS), 1KW Digital. 1.8Mhz – 61 MHz.
CB-1.5-1-1500EB is housed in a 4” x 4” x 2” waterproof housing with SO-239 input and stainless steel eye bolts on the side for ease of connection to your wire antenna (or top studs as desired). Top eye bolt acts as an antenna hoist. Also available with top studs for post or wall mounting (Model # CB-1.5-1-1500/5000TS). 5KW models are in a 4 " x 4" x 4" housing.
Loop antennas should be cut for 1005/F(MHz) in total length, where F (MHz) is the lowest frequency to be used. For 3.5MHz this equates to 288 foot perimeter (square, delta, multi-side ok). Vertiucal loops with pointy side up and longer bases and fed 1/4 wavelength down one side have a feedpoint impedance near 75 ohms for which this balun is well suited. A very good DX antenna!
For unbalanced 50 ohm input to unbalanced 75 ohm output use the CU-1.5-1500 or CU-1.5-5000.
Display Note: Product picture is 2:1 balun, 1:1 Unun but actual delivered product is CB/CU-1.5-1-1500/5000 as selected.
A simple ferrite ring filter on the DC power line can help suppress the RFI noise affecting the victim device or keep the DC power cord from acting as an antenna and radiating RFI into other victim devices. This kit is also useful on laptop computer supplies, routers, cable modems, wireless phone charges, etc.
Installation is quick and easy: Just wrap the DC power cord through the center of the ring filter as many times as you can and reinstall. For best results with long DC power lines, use one at the ring filter at the wall wart end (to prevent the wall wart power supply from using the DC line as an antenna) and another at the DC plug end (to prevent the electronics in the powered device from using the DC power cord as an antenna). Typical installation is shown below:
The filter suppresses RFI in from .1-100 MHz. Inside diameter is 3/4 inch/19 mm.
Since most households and office environments have multiple wall warts we offer the Wall Wart RFI Filter kit in bulk quantity packages.
Known RFI Generators include Roku/Sling-TV power adapter - Interference heard in the AM broadcast band and harmonics. Also many ethernet Cable/DSL modems, cell phone chargers, computer power adapters have the same issue: using the AC or DC side of the power supply as a radiating antenna. RFI solution is to use a linear power supply, change adapters or wall wart ferrite filters