Model BA-1-1500 is a 1:1 balun kit used to translate a 50 ohm unbalanced input to 50 ohms unbalanced at power levels up to 1500 watts PEP when used with a matched load. With a matched load the SWR will not exceed 1.5 over the frequency range 1.8 to 30 MHz. 1,500 PEP watt rating on a 25% duty cycle.
The kit consists of a F240 ferrite core, two colors of selected insulated wire, two SO-239 connectors (one for input and one for output connections) with stainless steel hardware, and an illustrated instruction manual with directions to assemble the kit as a 1 to 1 balun (unbalanced coax to balanced antenna/load) or unun (unbalanced to unbalanced). Leave one of the SO-239 connectors off on the output side and connect to your balanced antenna (dipole, beam driven elements, etc). To use as a line isolator/common mode choke, use both SO-239 connectors and insert in series with the coax feed line. For best results use one at the antenna and one for the rig side at the antenna tuner. The number of turns on the toroid can be changed to emphasize the low, mid or high portion of the 160-10 meter bands range as well as the choking impedance (see graph below). Assembly time is about 30 minutes. You can vary the number of turns to emphasize different frequency ranges.
BA-1-1500 Choking Z magnitude – 14 Turns and 10 Turns
Just add your custom enclosure, or optional enclosure box below, with the kit and you have a compete 1:1 current balun/unun.
A simple ferrite ring filter on the DC power line can help suppress the RFI noise affecting the victim device or keep the DC power cord from acting as an antenna and radiating RFI into other victim devices. This kit is also useful on laptop computer supplies, routers, cable modems, wireless phone charges, etc.
Installation is quick and easy: Just wrap the DC power cord through the center of the ring filter as many times as you can and reinstall. For best results with long DC power lines, use one at the ring filter at the wall wart end (to prevent the wall wart power supply from using the DC line as an antenna) and another at the DC plug end (to prevent the electronics in the powered device from using the DC power cord as an antenna). Typical installation is shown below:
The filter suppresses RFI in from .1-100 MHz. Inside diameter is 3/4 inch/19 mm.
Since most households and office environments have multiple wall warts we offer the Wall Wart RFI Filter kit in bulk quantity packages.
Known RFI Generators include Roku/Sling-TV power adapter - Interference heard in the AM broadcast band and harmonics. Also many ethernet Cable/DSL modems, cell phone chargers, computer power adapters have the same issue: using the AC or DC side of the power supply as a radiating antenna. RFI solution is to use a linear power supply, change adapters or wall wart ferrite filters