Model CU-9-1500 is a 9:1 multi-core unun housed in a NEMA enclosure box (4″ x 4″ x 2″) with top stud/eyebolt output used to translate a 50 ohm input up to 450 ohms at RF power levels up to 1500 watts PEP when used with a matched load.
Great for end fed antennas - great for FT-8 and digital mode power ratings are approximately 30% of PEP ratings into a matched 450 ohm load. For non-resonant end fed antennas, you will need a feed line choke on the coax. See typical antenna configuration notes below for details.
A simple ferrite ring filter on the DC power line can help suppress the RFI noise affecting the victim device or keep the DC power cord from acting as an antenna and radiating RFI into other victim devices. This kit is also useful on laptop computer supplies, routers, cable modems, wireless phone charges, etc.
Installation is quick and easy: Just wrap the DC power cord through the center of the ring filter as many times as you can and reinstall. For best results with long DC power lines, use one at the ring filter at the wall wart end (to prevent the wall wart power supply from using the DC line as an antenna) and another at the DC plug end (to prevent the electronics in the powered device from using the DC power cord as an antenna). Typical installation is shown below:
The filter suppresses RFI in from .1-100 MHz. Inside diameter is 3/4 inch/19 mm.
Since most households and office environments have multiple wall warts we offer the Wall Wart RFI Filter kit in bulk quantity packages.
Known RFI Generators include Roku/Sling-TV power adapter - Interference heard in the AM broadcast band and harmonics. Also many ethernet Cable/DSL modems, cell phone chargers, computer power adapters have the same issue: using the AC or DC side of the power supply as a radiating antenna. RFI solution is to use a linear power supply, change adapters or wall wart ferrite filters