Model CB-9-5000 is a 9:1 multi-core, balanced output balun housed in a NEMA enclosure box (4″ x 4″ x 2″) with top studs (TS) used to translate a 50 ohm input up to 450 ohms at RF power levels up to 5000 watts PEP when used with a matched load. With matched 450 ohm load the SWR over the frequency range 1 to 31 MHz is less than 2:1 on the coax feed side.
All power rating are PEP, 100%, continuous digital modes are 30% duty factor rating of PEP, FT-8 digital mode rated at 1500 watts.
Application note: If using 450 ohm ladder line on the output of the balun top studs, make sure the impedance seen at the balun end of the ladder line is near 450 ohms since the ladder line acts as an impedance transformer, the impedance at the end of the ladder line may be different than the characteristic 450 ohms of the ladder line. For example a 1/4 wavelength of ladder line will transform a high impedance at the antenna feed point to a very low impedance at the other end connected to the balun thus placing a very low impedance load on a balun expecting 450 ohms and such a load may damage the balun. The impedance seen at the balun output should be near 450 ohms for full power rating.
A simple ferrite ring filter on the DC power line can help suppress the RFI noise affecting the victim device or keep the DC power cord from acting as an antenna and radiating RFI into other victim devices. This kit is also useful on laptop computer supplies, routers, cable modems, wireless phone charges, etc.
Installation is quick and easy: Just wrap the DC power cord through the center of the ring filter as many times as you can and reinstall. For best results with long DC power lines, use one at the ring filter at the wall wart end (to prevent the wall wart power supply from using the DC line as an antenna) and another at the DC plug end (to prevent the electronics in the powered device from using the DC power cord as an antenna). Typical installation is shown below:
The filter suppresses RFI in from .1-100 MHz. Inside diameter is 3/4 inch/19 mm.
Since most households and office environments have multiple wall warts we offer the Wall Wart RFI Filter kit in bulk quantity packages.
Known RFI Generators include Roku/Sling-TV power adapter - Interference heard in the AM broadcast band and harmonics. Also many ethernet Cable/DSL modems, cell phone chargers, computer power adapters have the same issue: using the AC or DC side of the power supply as a radiating antenna. RFI solution is to use a linear power supply, change adapters or wall wart ferrite filters