Household RFI Kit - Suppress Noise, Reduce RFI to Household Electronics - 10 FiltersProduct DetailsMPN: RFI-HouseholdCountry/Region of Manufacture: United StatesFilter Power Rating (PEP watts): n/aChoking Impedance (ohms): 300-5000 ohms with multi-turnRFI Suppression Range (MHz): 1-300 MHz# Ferrite Filters: 10Typical Use:: household electronicsGENERIC HOUSEHOLD RADIO FREQUENCY INTERFERENCE (RFI) KIT
The RFI kit is designed to cure most household RFI problems. It contains ferrite toroids and beads selected to eliminate RFI from .1 to 300 MHz.The beads are easy to use, don’t require modification of the protected equipment and work in almost all cases, even when plug-in filters fail.
What is in the kit? Three 1/2" ID snap on beads, three 1/4" snap on beads, 3 wall wart filter rings to suppress noise and interference and a large 1.4" ID ring for AC power cord installation on RFI prone equipment like computers, Home Theater Systems, telephones, etc.
Plus full instructions in the RFI Tip
Sheet. A $49.50 retail value if purchased separately.
GENERIC HOUSEHOLD RADIO FREQUENCY INTERFERENCE (RFI) KIT
The RFI kit is designed to cure most household RFI problems. It contains ferrite toroids and beads selected to eliminate RFI from .1 to 300 MHz.The beads are easy to use, don’t require modification of the protected equipment and work in almost all cases, even when plug-in filters fail.
What is in the kit? Three 1/2" ID snap on beads, three 1/4" snap on beads, 3 wall wart filter rings to suppress noise and interference and a large 1.4" ID ring for AC power cord installation on RFI prone equipment like computers, Home Theater Systems, telephones, etc.
Plus full instructions in the RFI TipSheet. A $49.50 retail value if purchased separately.
Christmas lights or yard lights with switching DC power supplies are often the RFI source and a clamp on ferrite bead on the AC AND the DC side feeding the lights is needed to help suppress the switching power supply RFI noise. Suitable snap on beads are FSB31-1/2 for the 1-250 MHz range.
We have also had reported wireless HDTV boxes, and FOSCAM and AMCREST security camera systems causing RFI to garage door remote openers. Use our Garage Door Opener RFI kit to suppress the interference to the opener (VICTIM) – you need one kit for each opener. Maximize the distance from the camera to the openers may also help. Additionally shield cable to the garage door sensors may be needed depending on severity of the camera RFI.
Obvious Tech Note: make sure your remote batteries have enough energy to activate the GDO or the signal they transmit may not be large enough to over ride the RFI signal, but a fresh battery may be able to overcome the weak RFI source and allow the GDO to operate correctly.