FSB31-1-1, ID=1", RFI Range 1-300 MHzProduct DetailsMPN: FSB31-1Initial Permeability (@ 10KHz): 1500Material: MnZnMax cable size - in/mm: 1.0/25.4OD (A) - in/mm: 2.22/56.4ID (B) - in/mm: 1.02/25.9Length (C) - in/mm: 1.69/41.9Z (ohms per bead - single turn 1 MHz): 45Z (ohms per bead - single turn 5 MHz): 90Z (ohms per bead - single turn 10 MHz): 125Z (ohms per bead - single turn 25 MHz): 218Z (ohms per bead - single turn 100 MHz): 375Z ohms (per bead - single turn 250 MHz): 340Case/Box lot size: 36Also known as Big Clamp On. Very useful for AC/DC power, coax cable, etc. Use multiple turns for best results or multiple chokes in series (recommended for large amperage power cables). Always put +/- dc cables through the same ferrite filter so their fields cancel and the ferrite suppresses the common mode current on each cable.
These ferrites also work well for coax feed line chokes. Use 3 turns of RG-213 size coax thru center and put several ferrite in series each with 3 turns to make an excellent 80-10 meter high power feed line choke.
Also known as Big Clamp On. Very useful for AC/DC power, coax cable, etc. Use multiple turns for best results or multiple chokes in series (recommended for large amperage power cables). Always put +/- dc cables through the same ferrite filter so their fields cancel and the ferrite suppresses the common mode current on each cable.
These ferrites also work well for coax feed line chokes. Use 3 turns of RG-213 size coax thru center and put several ferrite in series each with 3 turns to make an excellent 80-10 meter high power feed line choke.
Christmas lights or yard lights with switching DC power supplies are often the RFI source and a clamp on ferrite bead on the AC AND the DC side feeding the lights is needed to help suppress the switching power supply RFI noise. Suitable snap on beads are FSB31-1/2 for the 1-250 MHz range.
We have also had reported wireless HDTV boxes, and FOSCAM and AMCREST security camera systems causing RFI to garage door remote openers. Use our Garage Door Opener RFI kit to suppress the interference to the opener (VICTIM) – you need one kit for each opener. Maximize the distance from the camera to the openers may also help. Additionally shield cable to the garage door sensors may be needed depending on severity of the camera RFI.
Obvious Tech Note: make sure your remote batteries have enough energy to activate the GDO or the signal they transmit may not be large enough to over ride the RFI signal, but a fresh battery may be able to overcome the weak RFI source and allow the GDO to operate correctly.