50:75 ohm (1.5:1) CUBE™ Balun/Unun, 1.8-61 MHz, 1.5KW PEP, DipoleProduct DetailsType: BALUN/UnunInput ohms/Output ohms: 50 in/75 outFrequency Range < 2:1 SWR (MHz): 1.8-61 MHzPEP Power Rating (watts): 1500Insertion Loss (dB): <.2Input Connector: SO-239 UHFOutput Connector(s): Top Studs/Side Eyebolts/So-239Transformer Topology: broadband binocular coreHardware Type: Stainless SteelEnclosure Size: 4" x 4" x 2"Weight (pounds): 2Available as a Unun for 50 ohm coax to 75 ohm coax or 75 unbalanced load or as a Balun for 50 ohm coax to balanced load such as a low (less than a wavelength high) dipole with either side eye bolts and halyard hoist or as post mountable top studs output.
This is an impedance transformer for 50 to 75 ohms and may require a additional feed line choke to keep common mode current off the coax braid.
CB-1.5-1500EB is useful for a dipole center feedpoint for low dipoles with 75 ohm antenna impedance.
Top stud version also useful for 75 ohm ladder line to coax interface
Available as a Unun for 50 ohm coax to 75 ohm coax or 75 unbalanced load or as a Balun for 50 ohm coax to balanced load such as a low (less than a wavelength high) dipole with either side eye bolts and halyard hoist or as post mountable top studs output.
This is an impedance transformer for 50 to 75 ohms and may require a additional feed line choke to keep common mode current off the coax braid.
CB-1.5-1500EB is useful for a dipole center feedpoint for low dipoles with 75 ohm antenna impedance.
Top stud version also useful for 75 ohm ladder line to coax interface
Christmas lights or yard lights with switching DC power supplies are often the RFI source and a clamp on ferrite bead on the AC AND the DC side feeding the lights is needed to help suppress the switching power supply RFI noise. Suitable snap on beads are FSB31-1/2 for the 1-250 MHz range.
We have also had reported wireless HDTV boxes, and FOSCAM and AMCREST security camera systems causing RFI to garage door remote openers. Use our Garage Door Opener RFI kit to suppress the interference to the opener (VICTIM) – you need one kit for each opener. Maximize the distance from the camera to the openers may also help. Additionally shield cable to the garage door sensors may be needed depending on severity of the camera RFI.
Obvious Tech Note: make sure your remote batteries have enough energy to activate the GDO or the signal they transmit may not be large enough to over ride the RFI signal, but a fresh battery may be able to overcome the weak RFI source and allow the GDO to operate correctly.