50:200 ohm (4:1) Dual Core Current Balun Kit, 1-55 MHz, 1500 watts PEP, for OCF, Loop, Ladder Line AntennasProduct DetailsMPN: BA-4-1000DCType: balun or ununInput ohms/Output ohms: 50 in, 200 outFrequency Range < 2:1 SWR (MHz): 1-55PEP Power Rating (watts): 1500 Watts PEPAntenna Compatability: Balun: Ladder line to coax interfacePurpose. Model BA-4-1500DC is a 4:1 dual core balun kit (assembly required from parts supplied) used to translate a 50 ohm input up to 200 ohms at RF power levels up to 1000 watts when used with a matched load. It provides conversion from unbalanced coax to balanced ladder line/antenna feed point and gives a 4:1 impedance step-up to reduce SWR on the coax. Place at the junction of the balanced line and the coax to convert from balanced line to unbalanced coax.
KIT Contents. The kit consists of a 2 ferrite toroidal cores, two colors of insulated wire, a SO-239 UHF connector with stainless steel hardware, and an instruction manual.
Assembly time: About 1 hour, illustrated manual included with purchase.
Radio Club idea:
Buy 10 for a club do it yourself construction project - you can learn something and also build an end fed antenna (just add wire).
Product picture shows assembled item of all components in kit.
NOTE: for higher power and a true current balanced 4:1, use our BA-4-1500DC dual core 4;1 balun kit
Purpose. Model BA-4-1500DC is a 4:1 dual core balun kit (assembly required from parts supplied) used to translate a 50 ohm input up to 200 ohms at RF power levels up to 1000 watts when used with a matched load. It provides conversion from unbalanced coax to balanced ladder line/antenna feed point and gives a 4:1 impedance step-up to reduce SWR on the coax. Place at the junction of the balanced line and the coax to convert from balanced line to unbalanced coax.
KIT Contents. The kit consists of a 2 ferrite toroidal cores, two colors of insulated wire, a SO-239 UHF connector with stainless steel hardware, and an instruction manual.
Assembly time: About 1 hour, illustrated manual included with purchase.
Radio Club idea:
Buy 10 for a club do it yourself construction project - you can learn something and also build an end fed antenna (just add wire).
Product picture shows assembled item of all components in kit.
NOTE: for higher power and a true current balanced 4:1, use our BA-4-1500DC dual core 4;1 balun kit
Christmas lights or yard lights with switching DC power supplies are often the RFI source and a clamp on ferrite bead on the AC AND the DC side feeding the lights is needed to help suppress the switching power supply RFI noise. Suitable snap on beads are FSB31-1/2 for the 1-250 MHz range.
We have also had reported wireless HDTV boxes, and FOSCAM and AMCREST security camera systems causing RFI to garage door remote openers. Use our Garage Door Opener RFI kit to suppress the interference to the opener (VICTIM) – you need one kit for each opener. Maximize the distance from the camera to the openers may also help. Additionally shield cable to the garage door sensors may be needed depending on severity of the camera RFI.
Obvious Tech Note: make sure your remote batteries have enough energy to activate the GDO or the signal they transmit may not be large enough to over ride the RFI signal, but a fresh battery may be able to overcome the weak RFI source and allow the GDO to operate correctly.