Mobile Station RFI Kits

CUBE Feed Line Choke, 1:1, 5KW PEP, .2-5 MHz, AM Broadcast, 160 and 80 Meter Common Mode Noise Filter, 30 to 42dB Noise Suppression

SKU CU-1-5000LF
$129.95
Bulk pricing available for quantities of 2 units or more
Output Connector Selection
1
Buy more, save more
QuantityPrice per itemDiscount
2 items$119.958% off
10 items$109.9515% off
Save this product for later
Customer reviews
No reviews yet. Only signed-in customers who bought this product can leave reviews. To leave a review, sign in
Share this product with your friends
CUBE Feed Line Choke, 1:1, 5KW PEP, .2-5 MHz, AM Broadcast, 160 and 80 Meter Common Mode Noise Filter, 30 to 42dB Noise Suppression
Product Details
Brand: Palomar Engineers
MPN: CU-1-5000LF
Effective Frequency Range (MHz): .2-5 MHz (see CMRR graph)
PEP Power Rating (watts): 5000
Common Mode Attenuation (db): 30-42 dB
Estimated Insertion Loss (db): .10 or less
Input Connector Type: SO-239 female
Output Connector Connector Type: 2 top studs, side eyebolts and halyard hoist or SO-239/N
Ground Connector (Y/N): none
Enclosure Size (LxWxH inches): 4 x 4 x 2

5000 Watt Rated 1:1 CUBE™ Choke - .2-5 MHz (effective to 100 KHz)

Th CU-1-5000LF unun is useful as common mode feed line chokes or coax to antenna interfaces. SO-239 output models can also be used with balanced antennas if a short coax cable “pigtail” is used on the output and connected to the antenna. Rated 5000 Watts PEP from .2-5 Mhz. Use as line isolator, antenna interface, or as a common mode choke to keep RF on the antenna and off the outside of the coax braid.

These high powered chokes are more effective then our sleeve feed line chokes due to multi-turn ferrite bead topology using high permeability ferrite cores which provides a higher choking impedance over a broad frequency range. Typical common mode rejection (CMRR) is 30-42 over the frequency range (see graph) For most effective results, use 1 choke at the antenna feed point to keep transmit RF off the coax braidand another at the radio end of the coax. Helps reduce noise floor too by choking off common mode neighborhood noise picked up on outside of coax braid.

Available in 1.5K and 5K PEP models. Picture shows 1.5KW model, but 5KW model is same size and frequency specs but 5KW PEP.


Mobile RFI kits work two ways: They suppress RFI from on board computers and other sensing/control devices in your vehicle that may cause your radio to be a VICTIM of RFI, and second they suppress RFI generated by your radio as a SOURCE which may affect your on board computers or other devices.  Mobile operations of HF radios (1-30 Mhz) tend to experience more RFI effects than VHF/UHF mobile stations.  If you have both HF and VHF installations in your vehicles, you may need both kits.

To address separate solutions we have developed two separate RFI kits: one for HF (1.8-300 MHz) mobile installations and another for VHF/UHF (30-1000 MHz) mobile installations.  Each kit uses the appropriate ferrite mix for the frequency range desired.