After many requests we have created a compact, special balun for Terminated Folded Dipoles (TTFD), Broad band Terminated Dipole/loop (BBTD) and V beam antennas with termination resistors at each end. The CB-16-1-1500 is a CUBE(TM) enclosure containing a multi-core, broadband 16:1 impedance transformer (50 ohm coax input to balanced 800 ohm output) in series with a 1:1 current balun for extra common mode current choking to keep RF current off the outside of the coax braid and on the antenna where it belongs. The extra choking action also means that the coax feed line will not act as a radiator causing unnecessary RF interference (RFI). Rated for full 1500 watts PEP and 450 watts CW (ICAS). 1.8Mhz – 31 MHz.
CB-16-1-1500EB is housed in a 4” x 4” x 2” waterproof housing with SO-239 input and stainless steel eye bolts on the side for ease of connection to your wire antenna. Top eye bolt acts as an antenna hoist. Also available with top studs for post or wall mounting (Model # CB-16-1-1500TS)
Termination resistor for the antenna is model # TR-1000-600 for single resistor termination.
AM broadcast transmits on a low frequency with large antennas. Consequently it takes a large antenna to receive the signals. Typical “antennas” are AC house wiring, phone lines, long satellite or cable TV cables, DSL/CAT5 lines running between rooms, etc. The device wires that connect to these “antennas” need to be choked with as many turns through the ferrite as possible. Some installation examples are shown below on this page.
For AC/ DC power cords and coax cables the F240-77 (2.4″ OD, 1.4″ ID) “Donut” toroid is the most popular. Also available are smaller toroid donuts and Mix 77 beads. Shown below is a graph with 8, 10, and 12 turns through the toroid – obviously more turns has higher choking impedance. Mix 77 toroid products are HERE and Mix 77 small beads (for small wires) are HERE
F240-77 Turns Comparison from .1 – 8.1 Mhz
Shown below is a graph of frequency response verses choking magnitude for a F240-77 in the AM Broadcast band for a 12 turn coil around the toroid. (Same info as above but different frequency range).
F240-77 Choking Impedance in AM Broadcast Band
Typical Installations for Donut/Ring Toroids
 AC Cable on F-240 Toroid – 6 turns |
 Ethernet Cable on F-240 Toroid – 7 turns |
 Audio or Mic cable on F240- 12 turns |
Extra Mix 75 Snap On Beads HERE – VERY effective for AM Broadcast RFI