The RFI-INVERTER is a common mode noise filter set which filters both the DC input and AC output of DC-AC inverters. These filters effectively isolate the DC power cord and AC output cable from acting as antennas for the internal switching power supply. The filters suppress RFI from 150 KHz to 10 MHz. Simple to install on cables without any device modification. DC filter is a ring and AC output filter is a snap on with 1" inside diameter hole.
For larger cables use the ACCF-3 and DCCF-3 ring filters with 3" inside diameters and use multiple turns on each cable for best results.
AC power strip shown in picture NOT INCLUDED - this is user supplied and shown for illustration of filter installation.
AM broadcast transmits on a low frequency with large antennas. Consequently it takes a large antenna to receive the signals. Typical “antennas” are AC house wiring, phone lines, long satellite or cable TV cables, DSL/CAT5 lines running between rooms, etc. The device wires that connect to these “antennas” need to be choked with as many turns through the ferrite as possible. Some installation examples are shown below on this page.
For AC/ DC power cords and coax cables the F240-77 (2.4″ OD, 1.4″ ID) “Donut” toroid is the most popular. Also available are smaller toroid donuts and Mix 77 beads. Shown below is a graph with 8, 10, and 12 turns through the toroid – obviously more turns has higher choking impedance. Mix 77 toroid products are HERE and Mix 77 small beads (for small wires) are HERE
F240-77 Turns Comparison from .1 – 8.1 Mhz
Shown below is a graph of frequency response verses choking magnitude for a F240-77 in the AM Broadcast band for a 12 turn coil around the toroid. (Same info as above but different frequency range).
F240-77 Choking Impedance in AM Broadcast Band
Typical Installations for Donut/Ring Toroids
 AC Cable on F-240 Toroid – 6 turns |
 Ethernet Cable on F-240 Toroid – 7 turns |
 Audio or Mic cable on F240- 12 turns |
Extra Mix 75 Snap On Beads HERE – VERY effective for AM Broadcast RFI