TECHNICAL NOTE: If you are building your own End fed Long Wire antenna, don't forget the end fed coax choke (or equivalent counterpoise) which is required to make the antenna operate correctly! End fed coax choke part numbers are SOFLC, EFFLC-240
Bullet End Fed Long Wire (EFLW) Antenna Wire Kit for end fed long wire antennas - choose 41, 71, 111, 155, 173, 203, 268 foot lengths complete with end insulator, #14 Insulated stranded copper wire and spade lugs and heat shrink for lugs for attachment to an optional Bullet 9:1 unun.
Insulators are a very stealthy, strong, pair of 2 PVC, 2 1/4" long. 1" wide. 1 1/8" hole separation wire antenna insulators and may be black, gray or white depending upon inventory
See related products for 9:1 transformers from 100 watts to 5KW, 9:1 toroid kits, and feed line chokes.
For a complete installation you will need 9:1 unun, wire kit, appropriate length of coax, and feed line choke (SOFLC is easiest to use and change position as you tune the antenna).
Bullet Antenna Length - feet (41, 71, 92, 111, 155, 173)
Corresponding Counterpoise length feet (16, 42, 90, 37, 95, 80) - place feed line choke on coax at this measured length from 9:1 unun
$129.95
Iron powder cores are more stable than ferrites and do not saturate as easily so they are best for tuned circuits, filters, and high power inductors. They come in different “Mixes” for use at different frequencies. For best “Q” use the Mix specified for your frequency.To find the number of turns to give the desired inductance for your coil use the formula below:
Turns = 100 x 
Toroid Dimensions
To order specify core size and mix (e.g. T200A-2). Available in sizes that have µH per 100 turns shown in table.
All iron powder cores are special orders. Please allow one week for shipment after order received.
The iron powder cores shown in the above tables are primarily used for either high power feed line chokes for common mode current reduction or for 4:1 and 9;1 very high power transmission line transformers.
For high power feed line chokes, choose the inside diameter of the iron powder core closest to the transmission line outside diameter and use 6-20 cores at the junction with the antenna feed.
For 4:1 (50/200 or 75/300 ohm) transmission line transformers in the range of 1.8-30 Mhz, select the size appropriate for the power level as follows:
T200A x 2 = 1.5KW
T300A x 2 = 2.5KW
T400A x 2 = 5KW
Use Mix 2 for all the above transmission line transformers. Fully assembled and enclosed units are available for each of the power levels. Click HERE for information.
4:1 transmission line transformers using iron powder cores are typically used for ladder line to 50 ohm coax connections
For .1 – 2 Mhz wide band transformers use Mix 26 which has a higher permeability and requires less turns to achieve a given inductance. Mix 2 has almost constant permeability from 1-30 Mhz. Mix 26 has an initial permeability of 75 at .1 Mhz and gradually decreases to about 10 at 30 Mhz. For high power AM broadcast range (.5-1.7 Mhz) transformer, use Mix 26 to reduce the turn count.
Minimum order for iron powder cores is $50
Shipping on larger cores in quantity may be more than $10 – email/call for quote.