5:1 CUBE™ Unun – Model CU-5-1500 (50:250 Ohm, 1.8-61 MHz, 1.5KW PEP)
Application. For traveling wave, end fed or portable 20-31 foot vertical antennas the 5:1 unun makes a good transformer for converting 50 ohm coax to a 250 ohm feed point. If you use the antenna on multiple bands, the feed point impedance may not always be 250 ohms and use of the unun at high (>350 ohms) or low (<100 ohms) will require reduced power input or the unun may have its power ratings exceeded and damage to the unun may occur. The (5:1 conversion ratio will change for loads other than 250 ohms unbalanced.
Typical application:
Also available as a balanced output – CB-5-1500
Fish Finder-Sonar-Depth Finder RFI KitProduct DetailsBrand: Palomar EngneersUPC: Does not applyMPN: RFI-FFType: NewCountry/Region of Manufacture: United States
Fish Finder – Sonar RFI Kit
Fish Finders/Sonar units can cause RFI “noise” in other electronic devices on a boat including audio and video systems, radar, SSB, wind/speed/depth instruments, etc. Likewise other electronic devices can also interfere with the fish finder and cause erroneous depth/temperature readings.
Palomar Engineers has developed a simple to install fish finder/sonar RFI suppression kit to solve the RFI noise problem aboard recreational and commercial boats.
Just slip a split bead on the transducer cable (1" ID) and use the 5 1/2" ID split beads on the fish finder/sonar readout unit transducer input and DC cables. Use the extra ferrites on other equipment needing protection like the Radar, radio, etc.
On Sale
DC Voltage Common Mode Noise Filter - Marine, RV, Communications, 600 Volts/30 AmpsDC Voltage Common Mode Noise Filter - Marine, RV, Communications, 600 Volts/30 AmpsSKU RFI-DC-30List price $109.95 Save 18%$89.95
Fish Finder – Sonar RFI Kit
Fish Finders/Sonar units can cause RFI “noise” in other electronic devices on a boat including audio and video systems, radar, SSB, wind/speed/depth instruments, etc. Likewise other electronic devices can also interfere with the fish finder and cause erroneous depth/temperature readings.
Palomar Engineers has developed a simple to install fish finder/sonar RFI suppression kit to solve the RFI noise problem aboard recreational and commercial boats.
Just slip a split bead on the transducer cable (1" ID) and use the 5 1/2" ID split beads on the fish finder/sonar readout unit transducer input and DC cables. Use the extra ferrites on other equipment needing protection like the Radar, radio, etc.