5:1 CUBE™ Unun – Model CU-5-1500 (50:250 Ohm, 1.8-61 MHz, 1.5KW PEP)
Application. For traveling wave, end fed or portable 20-31 foot vertical antennas the 5:1 unun makes a good transformer for converting 50 ohm coax to a 250 ohm feed point. If you use the antenna on multiple bands, the feed point impedance may not always be 250 ohms and use of the unun at high (>350 ohms) or low (<100 ohms) will require reduced power input or the unun may have its power ratings exceeded and damage to the unun may occur. The (5:1 conversion ratio will change for loads other than 250 ohms unbalanced.
Typical application:
Also available as a balanced output – CB-5-1500
Ferrite Ring and Snap On Combo Pack - 10 Rings (1.4" ID) + 10 Snap On Beads (1/2" ID) - Mix 75 (RFI Range 150 KHz-10 MHz) FREE USA SHIPPINGProduct DetailsBrand: Palomar EngineersUPC: Does not applyMPN: FRSCP-75-20Type: NEWCountry/Region of Manufacture: United StatesThis Ferrite Ring and Snap On Combo Pack features our two most popular ferrite filter sizes - the 1.4" ID ring for multiple turns of AC/DC or signal cables and the 1/2" ID snap on for signal cables like ethernet, audio, video, coax or data cables. You get 10 of the rings and ten 1/2" snap on ferrites - plenty to solve a complex RFi problem or several smaller ones.
The filters are useful for RF coax, AC/DC power cables, and device interconnection cables.
Always use a snap on or ring with a larger inside diameter than the diameter of the cable and use multiple turns if possible (2 turns through the snap on is the same as 4 snap ons with 1 turn).
Combo Pack includes the following:
F240-75 ring – 1.4″/35.6mm ID – 10 pieces
FSB75-1/2 – 1/2″/12.7mm ID – 10 pieces
Normal Retail price is $215 for these parts
On Sale
FSB75-1/4, ID=1/4", RFI Range 150Khz-10 MHzFSB75-1/4, ID=1/4", RFI Range 150Khz-10 MHzSKU FSB75-1/4-1List price $19.95 Save 50%$9.95
This Ferrite Ring and Snap On Combo Pack features our two most popular ferrite filter sizes - the 1.4" ID ring for multiple turns of AC/DC or signal cables and the 1/2" ID snap on for signal cables like ethernet, audio, video, coax or data cables. You get 10 of the rings and ten 1/2" snap on ferrites - plenty to solve a complex RFi problem or several smaller ones.
The filters are useful for RF coax, AC/DC power cables, and device interconnection cables.
Always use a snap on or ring with a larger inside diameter than the diameter of the cable and use multiple turns if possible (2 turns through the snap on is the same as 4 snap ons with 1 turn).
Combo Pack includes the following:
F240-75 ring – 1.4″/35.6mm ID – 10 pieces
FSB75-1/2 – 1/2″/12.7mm ID – 10 pieces
Normal Retail price is $215 for these parts
