5:1 CUBE™ Unun – Model CU-5-1500 (50:250 Ohm, 1.8-61 MHz, 1.5KW PEP)
Application. For traveling wave, end fed or portable 20-31 foot vertical antennas the 5:1 unun makes a good transformer for converting 50 ohm coax to a 250 ohm feed point. If you use the antenna on multiple bands, the feed point impedance may not always be 250 ohms and use of the unun at high (>350 ohms) or low (<100 ohms) will require reduced power input or the unun may have its power ratings exceeded and damage to the unun may occur. The (5:1 conversion ratio will change for loads other than 250 ohms unbalanced.
Typical application:
Also available as a balanced output – CB-5-1500
DSL/Cable Modem/Router/Ethernet/Internet RFI Kit - 3 FiltersProduct DetailsMPN: RFI-ROUTERType: NewCountry/Region of Manufacture: United StatesFilter Power Rating (PEP watts): n/aRFI Suppression Range (MHz): 1-300 MHz# Ferrite Filters: 3 or 5 depending on modelEnclosure Size (inches): n/aTypical Use:: 1-2 turns on all I/O cables
Use for DSL/cable modems, routers, access points, repeaters, Ethernet switches, etc.
The RFI-ROUTER-4 kit is meant to be used with a DSL Modem/Router with incoming DSL signal, up to 4 Ethernet lines and a single power DC power supply line coming into the device.Included are one snap on ferrite (3/4” hole) and two (3/4” hole) snap on split ferrite beads for the Ethernet outputs (2 per snap on using multiple turns for each cable). The additional 3/4" snap on is for the power supply line. The RFI-ROUTER-8 kit is identical but has 2 additional ferrite snap on for up to 4 additional ports,
Useful for all brands of computer equipment.
Use for DSL/cable modems, routers, access points, repeaters, Ethernet switches, etc.
The RFI-ROUTER-4 kit is meant to be used with a DSL Modem/Router with incoming DSL signal, up to 4 Ethernet lines and a single power DC power supply line coming into the device.Included are one snap on ferrite (3/4” hole) and two (3/4” hole) snap on split ferrite beads for the Ethernet outputs (2 per snap on using multiple turns for each cable). The additional 3/4" snap on is for the power supply line. The RFI-ROUTER-8 kit is identical but has 2 additional ferrite snap on for up to 4 additional ports,
Useful for all brands of computer equipment.