5:1 CUBE™ Unun – Model CU-5-1500 (50:250 Ohm, 1.8-61 MHz, 1.5KW PEP)
Application. For traveling wave, end fed or portable 20-31 foot vertical antennas the 5:1 unun makes a good transformer for converting 50 ohm coax to a 250 ohm feed point. If you use the antenna on multiple bands, the feed point impedance may not always be 250 ohms and use of the unun at high (>350 ohms) or low (<100 ohms) will require reduced power input or the unun may have its power ratings exceeded and damage to the unun may occur. The (5:1 conversion ratio will change for loads other than 250 ohms unbalanced.
Typical application:
Also available as a balanced output – CB-5-1500
Coax Jumper Choke - LMR-400 - RFI Range: 3-65 MHz, -25 dB Common Mode Noise Reduction, 5 KW PEPProduct DetailsMPN: JC-1-5000Country/Region of Manufacture: USASimple Hi Power Jumper Feed Line Choke
The simplest, most cost effective feed line choke is a ferrite ring installed as shown in the picture (at the antenna feed point) to stop feed line radiation or at the radio end of the coax to suppress common mode coax noise current on the coax braid.
Improves antenna pattern by preventing your dipole from becoming a tripole
Suppresses pesky coax braid radiation and RFI
Reduces coax braid common mode current up to -25 dB ( 4 "S" units) on receive
Use one choke for each antenna feed line
Add a double female barrel connector to act as an "extension" of the existing coax.
UHF (PL-259) Connectors on each end
DIY with your own coax with a FSB31-1-1 ferrite snap on (1-300 MHZ)
On Sale
FSB31-1, ID=1", RFI Range 1-300 MHz, Bulk Pack of 3FSB31-1, ID=1", RFI Range 1-300 MHz, Bulk Pack of 3SKU FSB31-1-3List price $58.50 Save 15%$49.95
Simple Hi Power Jumper Feed Line Choke
The simplest, most cost effective feed line choke is a ferrite ring installed as shown in the picture (at the antenna feed point) to stop feed line radiation or at the radio end of the coax to suppress common mode coax noise current on the coax braid.
Improves antenna pattern by preventing your dipole from becoming a tripole
Suppresses pesky coax braid radiation and RFI
Reduces coax braid common mode current up to -25 dB ( 4 "S" units) on receive
Use one choke for each antenna feed line
Add a double female barrel connector to act as an "extension" of the existing coax.
UHF (PL-259) Connectors on each end
DIY with your own coax with a FSB31-1-1 ferrite snap on (1-300 MHZ)
