5:1 CUBE™ Unun – Model CU-5-1500 (50:250 Ohm, 1.8-61 MHz, 1.5KW PEP)
Application. For traveling wave, end fed or portable 20-31 foot vertical antennas the 5:1 unun makes a good transformer for converting 50 ohm coax to a 250 ohm feed point. If you use the antenna on multiple bands, the feed point impedance may not always be 250 ohms and use of the unun at high (>350 ohms) or low (<100 ohms) will require reduced power input or the unun may have its power ratings exceeded and damage to the unun may occur. The (5:1 conversion ratio will change for loads other than 250 ohms unbalanced.
Typical application:
Also available as a balanced output – CB-5-1500
FSB31-1, ID=1", RFI Range 1-300 MHz, Bulk Pack of 3Product DetailsMPN: FSB31-1Initial Permeability (@ 10KHz): 1500Material: MnZnMax cable size - in/mm: 1.0/25.4OD (A) - in/mm: 2.22/56.4ID (B) - in/mm: 1.02/25.9Length (C) - in/mm: 1.69/41.9Z (ohms per bead - single turn 1 MHz): 45Z (ohms per bead - single turn 5 MHz): 90Z (ohms per bead - single turn 10 MHz): 125Z (ohms per bead - single turn 25 MHz): 218Z (ohms per bead - single turn 100 MHz): 375Z ohms (per bead - single turn 250 MHz): 340Case/Box lot size: 36Also known as Big Clamp On. Very useful for AC/DC power, coax cable, etc. Use multiple turns for best results or multiple chokes in series (recommended for large amperage power cables). Always put +/- dc cables through the same ferrite filter so their fields cancel and the ferrite suppresses the common mode current on each cable.. Bulk pack of 3
Also known as Big Clamp On. Very useful for AC/DC power, coax cable, etc. Use multiple turns for best results or multiple chokes in series (recommended for large amperage power cables). Always put +/- dc cables through the same ferrite filter so their fields cancel and the ferrite suppresses the common mode current on each cable.. Bulk pack of 3