The Ferrite Ring Combo Pack is a convenient solution for troubleshooting RFI/EMI from unknown frequencies or multiple frequencies that require multiple suppression mixes. Included in this combo pack are ten 2.4″ OD/1.4″ ID ring toroids as follows:
Mix 75 effective from .15-10 MHz including AM Broadcast band – quantity: 3
Mix 31 effective from 1-300 MHz for general purpose – quantity: 4
Mix 61 effective from 200-2000 MHz for cell phone, WIFI, HDTV, Cable TV interference – quantity: 3
Simple AC Power Cord Noise Filter Choke+ Power Cord included
The simplest, most cost effective AC power cord noise filter is a ferrite ring installed as shown in the picture (at the appliance AC input) to stop feed line appliance radiation back into the AC power line or into the radio/appliance to suppress common mode power line noise current on the AC power cord or to suppress common mode noise present on the power lines from degrading the performance of the attached device.
Keeps RFI out of appliances like TV, radios, computers, etc and like wise keeps noise generated by electronic devices from feeding the noise back into the AC power line and affecting other devices plugged into the same lines.
These chokes are cheap, easy solution for RFI issues. Just replace your existing power cord with these pre-wound cables and enjoy interference free operation.
Got your own AC power cable that needs a ferrite ring only? The use ACCF-1.4 ring. This ring also works well on switching power supplies (use 1 on AC input and another on the DC output or just order kit RFI-SMPS).
The ring toroids are useful for AC/DC common mode choking with multiple turns as shown below
 AC Cable on F-240 Toroid – 7 turns |
 DC Cable on F240 – 4 turns |
The ring toroids can also be used on coax or signal lines as shown below:
 RG58 12 turns on FT240 |
 Ethernet Cable on F-240 Toroid – 7 turns |
For RFI/EMI wrap as many turns as possible for higher choking (under 30 mHz).