1/2″/12.7mm max Cable Size Chokes
Model SLO-1/2 family of chokes are for use with ½” coax cable like RG-8, RG-213, 9913, LMR-400 and similar cables up to ½” diameter – works on all cable impedances (50, 62, 75, 90 ohms etc). 80-6 meters.Choose SLO-1/2 (5 beads) or for extended choking, choose SLO-1/2E (10 beads) or for super extended choking choose SLO-1/2SE (15 beads).
Each additional 5 beads is approximately 6 dB of common mode rejection (also 1 “S” unit of noise reduction).
Select chokes with minimum of 500 ohms at your frequency of interest for best results or upgrade to our CUBE(TM), or MC-1-3000 Maxi-Choker(TM) chokes up to 10,000 ohms choking.
Select 5 bead version for 80-2 meters use; 10 bead version for 160-6 meter use, 15 and 20 bead version for even higher choking power on 160-20 meter frequencies. Power rating is same as coax cable used power rating.
Snap On and Slip on Feed line chokes available in sizes to fix cables with outside diameters of 1/4", 3/8", 1/2", 3/4", 1" - check website for other size options.
The 5 bead, 1/2" model was previously part # BA-8
Testimonial:
KI7AY
Wanted to let you know that I was having a problem with RFI on 40m, but immediately after installing your Slip On Coax Feed Line Choke -1/2"/12.7mm cable, 1.8-300 MHz on a new RG-213 jumper between the IC-9100 and tuner, IT WENT COMPLETELY AWAY!
We specify impedance ratios as an output to input ratio where the output (or load) is given first and the input is given second (e.g. 100:50 (2:1) would mean a 100 ohm output and a 50 ohm input; a 25:50 (1:2) would mean a 25 ohm load and a 50 ohm input). Most all products use a 50 ohm input unless otherwise specified.
We have products that are available as kits for the do-it-yourself (DIY) person or fully assembled and tested units for the “Plug & Play” crowd.
Our impedance transformers are available using two different topologies: Binocular cores or toroid cores with multiple turns for increased effectiveness and wide band frequency transformations. We utilize single and multiple core transformers using high order windings when needed to extend product performance.
We rate the power ratings as watts PEP (Peak Envelop Power) with standard duty cycles for various modes. To determine the PEP rating required for your needs, see: Choke & Transformer Power Ratings
This website page serves as a link page to the frequency ranges of our impedance transformers configured as either baluns or ununs. You can click on a picture to go to the specific page about the products described in the picture.