KPA1500
This RFI Kit Includes are the following filters and installation guidelines:
RF Input:F240 ring – 5-9 turns of RG-58/8X size through center
RF Output:# 1 - FSB31-1 (Big Clamp on) – 3 turns of RG-8 size cable
RF Output:# 2 - FSB31-1 (Big Clamp on) – 3 turns of RG-8 size cable
PA KEY Cable: - FSB31-1/2 – multiple turns through choke – ½” diameter hole
DC Power Line: - FSB31-1 (Big Clamp on) – 2 turns through center
AC Line of DC Power Supply: - FSB31-1 (Big Clamp on) – 3 turns through center
Ports 7 to 15 : - FSB31-1/2 – multiple turns through choke – ½” diameter hole
Total ferrites: - F240 rings (1), FSB31-1 (4), FSB31-1/2 (10)
Also make sure you connect a good RF ground to the amplifier ground post.
We specify impedance ratios as an output to input ratio where the output (or load) is given first and the input is given second (e.g. 100:50 (2:1) would mean a 100 ohm output and a 50 ohm input; a 25:50 (1:2) would mean a 25 ohm load and a 50 ohm input). Most all products use a 50 ohm input unless otherwise specified.
We have products that are available as kits for the do-it-yourself (DIY) person or fully assembled and tested units for the “Plug & Play” crowd.
Our impedance transformers are available using two different topologies: Binocular cores or toroid cores with multiple turns for increased effectiveness and wide band frequency transformations. We utilize single and multiple core transformers using high order windings when needed to extend product performance.
We rate the power ratings as watts PEP (Peak Envelop Power) with standard duty cycles for various modes. To determine the PEP rating required for your needs, see: Choke & Transformer Power Ratings
This website page serves as a link page to the frequency ranges of our impedance transformers configured as either baluns or ununs. You can click on a picture to go to the specific page about the products described in the picture.