The Bullet-9B is a multi-core balun with a compact enclosure (looks like a bullet) enclosure that is lightweight and easy to transport for your fixed/portable ALE, T2FD or BBTD antenna systems. Also useful for rhombics and other wire antennas needing balanced 450 ohm output. Halyard hoist at top of balun for convenient attachment point. Input is via SO-239 coax connector and output with side eye bolt output.Use a 500 ohm non-inductive termination resistor for the T2FD when using this balun.
This transformer requires a feed line choke to isolate the coax feed line from the antenna. A coax noise filter at the radio end of the coax is also recommended to reduce common mode noise current picked up by the coax braid.
Available in 500 watts and 1500 watt models
Remember we over engineer our products, to out perform our competition - just compare the weight of our baluns to theirs and you will know we put much more into our products so you don't have to worry about failure at a critical moment.
We specify impedance ratios as an output to input ratio where the output (or load) is given first and the input is given second (e.g. 100:50 (2:1) would mean a 100 ohm output and a 50 ohm input; a 25:50 (1:2) would mean a 25 ohm load and a 50 ohm input). Most all products use a 50 ohm input unless otherwise specified.
We have products that are available as kits for the do-it-yourself (DIY) person or fully assembled and tested units for the “Plug & Play” crowd.
Our impedance transformers are available using two different topologies: Binocular cores or toroid cores with multiple turns for increased effectiveness and wide band frequency transformations. We utilize single and multiple core transformers using high order windings when needed to extend product performance.
We rate the power ratings as watts PEP (Peak Envelop Power) with standard duty cycles for various modes. To determine the PEP rating required for your needs, see: Choke & Transformer Power Ratings
This website page serves as a link page to the frequency ranges of our impedance transformers configured as either baluns or ununs. You can click on a picture to go to the specific page about the products described in the picture.