The Bullet-9B is a multi-core balun with a compact enclosure (looks like a bullet) enclosure that is lightweight and easy to transport for your fixed/portable ALE, T2FD or BBTD antenna systems. Also useful for rhombics and other wire antennas needing balanced 450 ohm output. Halyard hoist at top of balun for convenient attachment point. Input is via SO-239 coax connector and output with side eye bolt output.Use a 500 ohm non-inductive termination resistor for the T2FD when using this balun.
This transformer requires a feed line choke to isolate the coax feed line from the antenna. A coax noise filter at the radio end of the coax is also recommended to reduce common mode noise current picked up by the coax braid.
Available in 500 watts and 1500 watt models
Remember we over engineer our products, to out perform our competition - just compare the weight of our baluns to theirs and you will know we put much more into our products so you don't have to worry about failure at a critical moment.
Testimonial
Hi Bob,
Radio: Flex-6700 running barefoot -10 to 100 Watts max.
Antenna: MFJ-1216 – 160/80 meter OCFD wire antenna with matching network.
Elevation: Over 60 feet AGL – fully extended.
Installed: Mid November 2013
I operate mainly on the digital modes running less than 50 Watts. All of the sudden after a few days operating with this antenna, I start to have RFI and my radio was acting up; such as changing bands, SWR changing values, radio failures and turning off. However, when I used my Hy-Gain 18 HT vertical on the same band none of the abnormality occurred.
I contacted MFJ and confirm that what I was noticing was a failure of their “matching network” AKA balun. They offered no solutions. Then I contacted Palomar Engineers and bought the 1:1 new toroid RF beads. I called Palomar Engineers and I happened to talked to you directly; regarding the on going issue with the MFJ antenna. I found out that the 1:1 balun was not what I needed (I was miss-informed by MFJ that it was 1:1 matching network.)
You offered to make the required balun 4:1 and the rest is history.
Here are my findings:
- No more RFI displayed on the monitors.
- Radio not acting up or turning off.
- The SWR at 160/80 meter is 1.2:1
- No antenna tuner required. (radio goes to Bypass automatically.)
- Worst SWR is on 10 meter with a 2:1 but still usable, with antenna tuner 1.5.
- One happy OCFD user!
Thanks to Palomar Engineers design and engineering for solving this issue.
73, Ernest – W4EG