NEW PRODUCT ALERT
SIGNALPEN(TM) PENCIL SIZE RF Detector, 60 Hz to 1.2 GHz, Miliwatts to Kilowatts, Direct Contact or Inductive Detector, No Battery, Fits in Shirt Pocket!
BULLET™ END FED ANTENNAS - 80-6 Meter - 100/500/1500 Watts
SHORTER, SAFER, MORE BANDS THAN EFHW
Bullet end fed antennas are shorter than conventional dipoles, yet deliver superior performance on many bands using the radiating coax as part of the antenna. They come in a variety of power levels, and work great for portable or permanent installations. Thousands in use world-wide! Selected models available at Ham Radio Outlet and all available on company website where full details on these antennas and many accessories are shown.
BULLET-2006 Antenna (Click for more info)
BULLET-4006 Antenna (Click for more info)
BULLET-8006 Antenna (click for more info)
Palomar Engineers Antenna Info Sheet
Popular Categories
HF Wire Antennas - End Feds, Off Center Fed, Loop, T2FD/BBTD, Dipoles and Zepps, 160-6 Meters, Wire, Hardware and Instructions for you.
Ferrite Products - Rings, Snap On, Slip On, useful from 150KHz - 2 GHZ, Mixs 31, 43, 52, 61, 75
RFI Solutions - Consumer Electronics, Computer, Audio/Home Theater, Wall Warts, Solar and more!
Baluns/Ununs/Chokes (1:1-81:1 ratios) for RX, 100/500/1500/5000 Watts including Hybrids (with choke) and Multi-Ratio
Radio Transceiver/Linear Amplifier RFI Kits - All Brands, VLF, HF to UHF
Noise Filters - Coax, AC and DC power 100 KHz - 150 MHz, up to -48 dB noise suppression - hear DX again!
Palomar Engineers® products are over engineered to outperform the competition without being over priced!Buy DIRECT, on eBay or at Ham Radio Outlet stores nationwide, HRO Product List HERE QUICK and EASY RFI Solutions for Consumer Electronics - FREE RFI Tip Sheet |
Featured Products
Testimonial
Hi Bob,
Radio: Flex-6700 running barefoot -10 to 100 Watts max.
Antenna: MFJ-1216 – 160/80 meter OCFD wire antenna with matching network.
Elevation: Over 60 feet AGL – fully extended.
Installed: Mid November 2013
I operate mainly on the digital modes running less than 50 Watts. All of the sudden after a few days operating with this antenna, I start to have RFI and my radio was acting up; such as changing bands, SWR changing values, radio failures and turning off. However, when I used my Hy-Gain 18 HT vertical on the same band none of the abnormality occurred.
I contacted MFJ and confirm that what I was noticing was a failure of their “matching network” AKA balun. They offered no solutions. Then I contacted Palomar Engineers and bought the 1:1 new toroid RF beads. I called Palomar Engineers and I happened to talked to you directly; regarding the on going issue with the MFJ antenna. I found out that the 1:1 balun was not what I needed (I was miss-informed by MFJ that it was 1:1 matching network.)
You offered to make the required balun 4:1 and the rest is history.
Here are my findings:
- No more RFI displayed on the monitors.
- Radio not acting up or turning off.
- The SWR at 160/80 meter is 1.2:1
- No antenna tuner required. (radio goes to Bypass automatically.)
- Worst SWR is on 10 meter with a 2:1 but still usable, with antenna tuner 1.5.
- One happy OCFD user!
Thanks to Palomar Engineers design and engineering for solving this issue.
73, Ernest – W4EG