HF High Power Impedance Transformers

442300386 - HF High Power Impedance Transformers
+2

Troubleshooter's Ferrite Pack Mix 31, 75, 61, 1/2" ID Snap-On, RFI Range 150 KHz-2000 MHz, 10 Pieces

Store/Ferrite Core Products/Mix 31/Snap On - Mix 31 - RFI Range 1-300 MHz
SKU TFP-1/2-10
$69.95
Bulk pricing available for quantities of 2 units or more
1
Buy more, save more
QuantityPrice per itemDiscount
2 items$64.957% off
10 items$59.9514% off
Save this product for later
Customer reviews
Reviews only from verified customers
No reviews yet. You can buy this product and be the first to leave a review.
Share this product with your friends
Pin it
Troubleshooter's Ferrite Pack Mix 31, 75, 61, 1/2" ID Snap-On, RFI Range 150 KHz-2000 MHz, 10 Pieces
Store/Ferrite Core Products/Mix 31/Snap On - Mix 31 - RFI Range 1-300 MHz
Product Details
Material: 31, 61, 75
Max cable size - in/mm: .5/12.7
OD (A) - in/mm: 1.22/31
ID (B) - in/mm: .514/13.1
Length (C) - in/mm: 1.55/5

Ferrite Snap On, ID = .514in/13.1 mm, 10 Pack for troubleshooting unknown RFi frequencies

Use Mix 31 for 1-300 MHz - 4 pieces

Use Mix 61 for 200- 2000 MHz - 3 pieces

Use Mix 75 for150 KHz-10 MHz - 3 pieces

At last a troubleshooter's ferrite kit that works from 150 KHz to 2 H=GHZ. Now you can suppress RFi from unknown frequency ranges with a full spectrum of ferrite cores that have a 1/2" ID large enough for multiple turns of many common data and signal wires. Try 1 mix and see if it has an effect and if not then try another until you suppress the unknown frequencies. Or use them all to provide protection across a broad frequency range. 3 ferrite cores provide at least 500 ohms in the frequency band to give a measurable difference in RFI and noise suppression.

Square or Hex sided depending upon inventory stock

Show More
Display prices in:USD
The high power ferrite impedance transformer series (> 1:1), configured with outputs to act as a baluns (unbalanced coax in to balanced load output) or as ununs (unbalanced coax input to unbalanced load output) are designed for demanding radio transmitter stations that run over 1,000 watts PEP or run continuous modes like AM, digital, RTTY, FM, etc. at high power levels. Radio contest operators, commercial shortwave broadcast, and industrial and commercial stations use these transformers for for a variety of balanced and unbalanced antenna loads.  Baluns are typically used for balanced loads and antennas like dipoles, loops, log periodics, and direct feed yagi/beams.  Ununs are used  with verticals, end fed wires, horizontal dipoles, G5RV/ZS6BKW, Zepps, vertical wire beams, etc).  All products are in an enclosed NEMA water resistant box with SO-239 input connector and stainless steel side/top studs with wing nuts or side and top eyebolts.  The enclosure box has mounting “side feet” for attachment to a post or antenna boom using nylon ties.