HF High Power Impedance Transformers

442300472 - HF High Power Impedance Transformers
+8
+7
+6
+5
+4
+3
+2

FSB31-1, ID=1", RFI Range 1-300 MHz, Bulk Pack of 3

Store/Ferrite Core Products/Mix 31/Snap On - Mix 31 - RFI Range 1-300 MHz
SKU FSB31-1-3
$49.95
On Sale
List price $58.50 Save 15%
3
$18.32
1
Save this product for later
Customer reviews
Reviews only from verified customers
No reviews yet. You can buy this product and be the first to leave a review.
Share this product with your friends
Pin it
FSB31-1, ID=1", RFI Range 1-300 MHz, Bulk Pack of 3
Store/Ferrite Core Products/Mix 31/Snap On - Mix 31 - RFI Range 1-300 MHz
Product Details
MPN: FSB31-1
Initial Permeability (@ 10KHz): 1500
Material: MnZn
Max cable size - in/mm: 1.0/25.4
OD (A) - in/mm: 2.22/56.4
ID (B) - in/mm: 1.02/25.9
Length (C) - in/mm: 1.69/41.9
Z (ohms per bead - single turn 1 MHz): 45
Z (ohms per bead - single turn 5 MHz): 90
Z (ohms per bead - single turn 10 MHz): 125
Z (ohms per bead - single turn 25 MHz): 218
Z (ohms per bead - single turn 100 MHz): 375
Z ohms (per bead - single turn 250 MHz): 340
Case/Box lot size: 36

Also known as Big Clamp On. Very useful for AC/DC power, coax cable, etc. Use multiple turns for best results or multiple chokes in series (recommended for large amperage power cables). Always put +/- dc cables through the same ferrite filter so their fields cancel and the ferrite suppresses the common mode current on each cable.. Bulk pack of 3

Show More
Display prices in:USD
The high power ferrite impedance transformer series (> 1:1), configured with outputs to act as a baluns (unbalanced coax in to balanced load output) or as ununs (unbalanced coax input to unbalanced load output) are designed for demanding radio transmitter stations that run over 1,000 watts PEP or run continuous modes like AM, digital, RTTY, FM, etc. at high power levels. Radio contest operators, commercial shortwave broadcast, and industrial and commercial stations use these transformers for for a variety of balanced and unbalanced antenna loads.  Baluns are typically used for balanced loads and antennas like dipoles, loops, log periodics, and direct feed yagi/beams.  Ununs are used  with verticals, end fed wires, horizontal dipoles, G5RV/ZS6BKW, Zepps, vertical wire beams, etc).  All products are in an enclosed NEMA water resistant box with SO-239 input connector and stainless steel side/top studs with wing nuts or side and top eyebolts.  The enclosure box has mounting “side feet” for attachment to a post or antenna boom using nylon ties.