The CB-1-1500DS Antenna Antenna Tuner Balun is a 50 ohm to 50 ohm, multi-core feed line choke designed to provide high choking impedance between a balanced ladder line feed line antennas (zepp, G5RV, extended double zepp, etc.) or single ended antennas like 1/4 wave verticals and a remote antenna tuner (including an automatic antenna tuner with only a single output and ground, like SGC-230, Icom AH-4, etc) short 50 ohm coax feed line (to antenna tuner) at a power of 1500 watts PEP from 1.8 to 61 MHz.
The input and output connectors are double studs marked +/-.
The CB-1-1500DS is configured as a Guanilla transmission line transformer with balanced outputs (current balun configuration). It is best used when ladder line impedance seen at the end of the ladder line to balun connection is close to 50-150 ohms. Enclosure box is 4″ x 4″ x 2″. Typical choking impedance range is 1K-10K ohms from 1-61 MHz.
Typical ZS6BKW multi-band antenna with CB-1-1500 or CB-1-5000
Due to many requests for antenna static bleeders, we have developed a product line of static bleeders for coax and for ladder line applications. Static electricity is caused by many situations including high desert wind, atmospheric conditions, etc. You may hear static crashes or have a buildup of static electricity that my be annoying during a radio conversation and it may be harmful to solid state electronics if high voltages are present on the RF input to your equipment.
A static “Bleeder” which shorts the direct static voltage to ground while leaving the RF frequency voltage unaffected if very beneficial particularly to those operations in desert conditions where low humidity, high static buildup are quite common. The SB-1 and SB-2 coax static bleeders work on coax line and the SB-3 static bleeder is meant for ladder line.
THESE DEVICES ARE NOT FOR LIGHTNING PROTECTION AND PROVIDES NO PROTECTION FOR LIGHTNING STRIKES!!!!!
The CB-1-1500DS Antenna Antenna Tuner Balun is a 50 ohm to 50 ohm, multi-core feed line choke designed to provide high choking impedance between a balanced ladder line feed line antennas (zepp, G5RV, extended double zepp, etc.) or single ended antennas like 1/4 wave verticals and a remote antenna tuner (including an automatic antenna tuner with only a single output and ground, like SGC-230, Icom AH-4, etc) short 50 ohm coax feed line (to antenna tuner) at a power of 1500 watts PEP from 1.8 to 61 MHz.
The input and output connectors are double studs marked +/-.
The CB-1-1500DS is configured as a Guanilla transmission line transformer with balanced outputs (current balun configuration). It is best used when ladder line impedance seen at the end of the ladder line to balun connection is close to 50-150 ohms. Enclosure box is 4″ x 4″ x 2″. Typical choking impedance range is 1K-10K ohms from 1-61 MHz.
Typical ZS6BKW multi-band antenna with CB-1-1500 or CB-1-5000