Inverted L End Fed Antenna System with Coax Interface including 1:1 feed line choke - 160/80M and 1.5KW/5KW PEP options
Inverted L antenna with radiator and counterpoise for simple installation - choose 80/160 meters and 1.5KW/5KW feed line choke included inside weatherproof enclosure. Separate counterpoise and ground connections
* Complete package - just add coax
* works single band with ease
* can be configured as vertical or inverted L configuration
* Choice of 1.5K, or 5KW PEP rated choke to suit power needs
After many requests we have created a compact, special interface box with internal feed line choke and separate connections for counterpoises (not grounded) and ground connection. The 1:1 choke keeps RF current off the outside of the coax braid and on the antenna where it belongs. The extra choking action also means that the coax feed line will not act as a radiator causing unnecessary RF interference (RFI).
80 M radiator/counterpoise is 70 Feet (you get 1 each) - adjust length to your favorite frequency
160 M radiator/counterpoise is 130 Feet (you get 1 each) - adjust length to your favorite frequency
Antenna is tuned to you favorite frequency by shortening the counterpoise (roll it up or cur length) while keeping the radiator length constant.
Choose 1,5KW PEP or 5KW PEP options.
1.5KW and 5KW are in 4" x 4" x 2" enclosure. 1.5KW is 3 pounds, 5KW is 5 pounds. 2 antenna insulators are included.
ADD CMNF-1500 (1.5KW) or CMNF-5000 (5KW) common mode noise filter at radio end of coax to reduce common mode noise up to 6 "S" units on long coax runs!
SLIP-ON FERRITE BEADS
Baluns are used to connect balanced antennas to unbalanced transmission lines (Coaxial cable) and Ununs are used to connect unbalanced transmission lines to unbalanced transmission lines or unbalanced antennas (e.g. verticals). In the case of 1:1 baluns the input is usually an unbalanced coax cable and the output load is a two terminal balanced load like an antenna. Ununs are also called line isolators, feed line chokes, and 1:1 coaxial baluns (incorrectly). 1:1 Baluns and ununs stop common mode currents (flowing on the outside of the coax braid due to skin effect) when they are located at the antenna feedpoint. They can also be used as “line isolators/chokes” anywhere along the cable to suppress flow of induced RF (antenna near field radiation and neighborhood noise pickup) which helps suppress RFI into the radio receiver/transmitter. For best results, put one at the antenna feed point connection, and one at the radio room entrance, and for difficult common mode current cases, one every 1/4 wavelength along the antenna feed line. For low (below 3 MHz) frequencies, use two 5 bead baluns in series to double the choking impedance or order the 10 bead or 15 bead version for higher choking power.