Hybrid 9:1 Current Balun + 1:1 Current Balun in one enclosure, 1.8-61 MHz, 1.5KW PEP - BBTD, T2FD Antenna
| Quantity | Price per item | Discount |
| 2 items | $127.95 | 9% off |
| 10 items | $114.95 | 18% off |
| 100 items | $108.95 | 22% off |
After many requests we have created a compact, special hybrid balun for Terminated Folded Dipoles (TTFD) and Broad band Terminated Dipole/loop (BBTD) antennas. The CB-9-1-1500 is a CUBE(TM) enclosure containing a multi-core, broadband 9:1 impedance transformer (50 ohm coax input to balanced 450 ohm output) in series with a 1:1 current balun for extra common mode current choking to keep RF current off the outside of the coax braid and on the antenna where it belongs. The extra choking action also means that the coax feed line will not act as a radiator causing unnecessary RF interference (RFI). Rated for full 1500 watts PEP and 450 watts CW (ICAS). 1.8Mhz – 61 MHz.
CB-9-1-1500EB is housed in a 4” x 4” x 2” waterproof housing with SO-239 input and stainless steel eye bolts on the side for ease of connection to your wire antenna. Top eye bolt acts as an antenna hoist. Also available with top studs for post or wall mounting (Model # CB-9-1-1500TS)
Termination resistor for the antenna is a Model # TR-500-600
N connector versions are customer made to order - please allow up to 10 days after order before shipment.
Many designs for BBTD antennas using 9:1 baluns at HFLINK.COM
SLIP-ON FERRITE BEADS
Baluns are used to connect balanced antennas to unbalanced transmission lines (Coaxial cable) and Ununs are used to connect unbalanced transmission lines to unbalanced transmission lines or unbalanced antennas (e.g. verticals). In the case of 1:1 baluns the input is usually an unbalanced coax cable and the output load is a two terminal balanced load like an antenna. Ununs are also called line isolators, feed line chokes, and 1:1 coaxial baluns (incorrectly). 1:1 Baluns and ununs stop common mode currents (flowing on the outside of the coax braid due to skin effect) when they are located at the antenna feedpoint. They can also be used as “line isolators/chokes” anywhere along the cable to suppress flow of induced RF (antenna near field radiation and neighborhood noise pickup) which helps suppress RFI into the radio receiver/transmitter. For best results, put one at the antenna feed point connection, and one at the radio room entrance, and for difficult common mode current cases, one every 1/4 wavelength along the antenna feed line. For low (below 3 MHz) frequencies, use two 5 bead baluns in series to double the choking impedance or order the 10 bead or 15 bead version for higher choking power.