The simplest, most cost effective feed line choke is a ferrite ring installed as shown in the picture (at the antenna feed point) to stop feed line radiation or at the radio end of the coax to suppress common mode coax noise current on the coax braid.
Great choke for log periodics, HF beams, Transceiver/Amp isolation
Improves antenna pattern by preventing your dipole from becoming a tripole
Suppresses pesky coax braid radiation and RFI
Reduces coax braid common mode current up to -40 dB ( 6 “S” units) on receive
Use one choke for each antenna feed line
Add a double female barrel connector to act as an “extension” of the existing coax.
Termination Resistor, 600 Ohm Non-Inductive for T2FD, BBTD, Rhombic, 1-61 MHz, 600 Watts
Broadband, Non-Inductive Termination Resistor load used on many terminated antenna types such as T2FD, Broadband Terminated Dipole (BBTD), Rhombics and others
Resistive Value: 600 ohms (+/- 10%)
SSB (25% duty cycle) rating in Watts: 600
CW/FT8 (50% duty cycle) in watts: 300
Length (tip to tip) Inches: 11 1/4"
Width inches: 2 1/4"
Inductance < 20 nH (1-61 MHz)Internal Resistance Wattage: 200 watts
