The Yaesu FTDX 5000 is an exceptional radio and deserves an excepitionla RFI and noise reduction kit which we have designated as the "ELITE" series of Transceiver Kits. This kit is designed to be installed on your radio transceiver to reduce Radio Frequency Interference (RFI) caused by common mode current on the multiple coax connectors of your radio, the AC power input, USB, DMU, Audio, rotor, amplifier ALC/Send, mouse, mic and additional interconnect cables. The ELITE Kit has 6 ferrite ring (1.4" ID) filters and 18 ferrite snap on (1/2") filters and instruction manual. Kit can also be used for the Yaesu 5000MP
This kit will help reduce or eliminate:
1. “Hot mic” RFI caused by poor grounding of antennas or common mode currents from linear amps feeding unbalanced (coax fed) antennas without baluns/line isolators.
2. RFI to neighbor’s electronic devices including audio/video systems, computers, telephones, garage door openers, etc.
3. RFI to your other radios, audio/video systems, computers, telephones, etc.
A side benefit is a reduction in noise floor in your receiver depending on the amount of noise being introduced by common mode currents (which are blocked/reduced by the chokes in this kit).
These chokes use a special mix of ferrite core material that is effective in suppressing radio frequency interference from transmitters and high noise floor on receivers.
The split beads beads are easy to use, don’t require modification of the protected equipment and work in almost all cases, even when plug-in filters fail.
Use of the chokes often helps cure SWR problems between transceiver and a linear amp and between transceiver and antenna tuner or direct to antenna. The DC power line choke helps keep common mode current out of the power line which could cause interference to other devices connected to the same power line if not suppressed.
For additional RFI suppression, use a feed line choke at the antenna feed point to suppress common current on the coax feed line and a coax noise filter at the radio end of the coax to reduce common mode noise.If you use a linear amplifier use an amplifier RFI kit for additional RFI interference suppression.
Generator RFI testimonial:
Bob Received your order in a timely fashion. Tried the generator kit on Sunday & it drops the noise from S9 to S5 and took out all the electrical noise. I may want some more toroids from you at some point for other interference problems I have here. Ken VE3KCY
Using an amplifier? Don’t forget our Linear Amplifier RFI Kits
Want to make up your own RFI kits for a particular operation? Here are links to some of typical RFI solutions used in portable operations:
If you use a computer for logging in your portable operations, RFI getting into computers will often lock up your computer and/or radio and a computer RFI suppression kits may be helpful
Make your expedition or portable operation a pleasant and fun outing and remember to take along your RFI kits so you have more time to operate rather then to troubleshoot intermittent or noisy receiver conditions.
Portable Antenna Kits
If you need an effective portable antenna which folds up for transport yet is easy to deploy at your operating site, consider the BULLET series of end fed wire antennas.
BULLET Antennas (click on link or picture for more info)
