Portable Operation RFI Kits

CUBE™ Vertical Antenna Feed Line Choke, 1.8-61 MHz, 1.5KW

SKU CUV-1-1500
$109.95
Output Power (PEP)
1
Save this product for later
Customer reviews
No reviews yet. Only signed-in customers who bought this product can leave reviews. To leave a review, sign in
Share this product with your friends
CUBE™ Vertical Antenna Feed Line Choke, 1.8-61 MHz, 1.5KW
Product Details
UPC: Does not apply
Brand: Palomar Engineers
MPN: CUV-1-1500, CUV-1-5000
Type: New
Country/Region of Manufacture: United States
Effective Frequency Range (MHz): 1-61 MHz
PEP Power Rating (watts): 15005000
Estimated Insertion Loss (db): .10
Input Connector Type: SO-239 female
Output Connector Connector Type: 1/4" stud/wing nut
Ground Connector (Y/N): 1/4 stud/wing nut
Enclosure Size (LxWxH inches): 4 x 4 x 2

Feed Line Chokes for Vertical Antenna with radials/counterpoise

Feed line chokes for verticals require a special arrangement to isolate the coax feed line from the radials and ground system. Schematically, a good feed line choke for verticals with radials should be built as follows:

Vertical Antenna Schematic 2 259x300 - Portable Operation RFI Kits

Our CUV-1-1500 and CUV-1-5000 feed line chokes are all internally connected to isolate the coax feed line as shown above.


1500 Watt Rated 1:1 Feed line Choke (Unun) for Verticals with radials

Th CUV-1-1500 unun is a common mode feed line choke for vertical antennas with radials that need to be isolated from the coaxial feed line to keep common mode current from using the coaxial braid as another radial. Very effective with high choking of 1K-5K from 1.8-61 MHz and also incorporates two side studs/wingnut terminals for radial or ground connection at the antenna while isolating the coax feed line braid from the radials via the internal common mode feed line choke. Top terminal with stud/wingnut for vertical connection enclosed in a 4″ x 4″ x 2″ box..


To reduce receiver common mode noise for long runs of coax to your antenna, use a MC-1-1500 or CU-1-1500 feed line choke at the station end of the coax.

Portable operation is fun but also brings challenges to the radio operator concerning receiver “noise” levels, RF interference from adjacent sources including close by transmitting stations, and RFI from portable generators.  A typical scenario and some suggested Palomar product solutions are shown in the picture below:

Generator RFI testimonial:

Bob 

Received your order in a timely fashion. Tried the generator kit on Sunday & it drops the noise from S9 to S5 and 
took out all the electrical noise.  I may want some more toroids from you at some point for other interference problems
I have  here.
Ken VE3KCY

Using an amplifier?  Don’t forget our Linear Amplifier RFI Kits

Want to make up your own RFI kits for a particular operation? Here are links to some of  typical RFI solutions used in portable operations:

AC/DC common mode filters

Feed Line chokes

Coax Noise Filters

If you use a computer for logging in your portable operations, RFI getting into computers will often lock up your computer and/or radio and a computer RFI suppression kits may be helpful

Computer RFI Kits

Make your expedition or portable operation a pleasant and fun outing and remember to take along your RFI kits so you have more time to operate rather then to troubleshoot intermittent or noisy receiver conditions.

Portable Antenna Kits

If you need an effective portable antenna which folds up for transport yet is easy to deploy at your operating site, consider the BULLET series of end fed wire antennas.

BULLET Antennas (click on link or picture for more info)

Bullet Antenna Product 300x292 - Portable Operation RFI Kits