Switch Mode Power Supply (SMPS) Common Mode RFI/Noise Reduction Filter KitProduct DetailsMPN: RFI-SMPSType: NEWCountry/Region of Manufacture: United StatesFilter Power Rating (PEP watts): n/aRFI Suppression Range (MHz): 150 KHz - 10 MHzTypical Use:: SMPS common mode noise suppressionThe RFI-SMPS is a common mode noise reduction filter set which filters both the AC input and DC output of common SMPS power supplies. These filters effectively isolate the AC power cord and DC output cable from acting as antennas for the internal switching power supply generated noise. The mix 75 filters suppress RFI fundamental frequencies (and the harmonics also) from 150 KHz to 10 MHz. Simple to install on cables without any device modification.
Used for amateur and commercial radio transceiver power supplies, cable TV boxes, laptop computers, or any electronic device powered by an external switching power supply.
The RFI-SMPS is a common mode noise reduction filter set which filters both the AC input and DC output of common SMPS power supplies. These filters effectively isolate the AC power cord and DC output cable from acting as antennas for the internal switching power supply generated noise. The mix 75 filters suppress RFI fundamental frequencies (and the harmonics also) from 150 KHz to 10 MHz. Simple to install on cables without any device modification.
Used for amateur and commercial radio transceiver power supplies, cable TV boxes, laptop computers, or any electronic device powered by an external switching power supply.
Christmas lights or yard lights with switching DC power supplies are often the RFI source and a clamp on ferrite bead on the AC AND the DC side feeding the lights is needed to help suppress the switching power supply RFI noise. Suitable snap on beads are FSB31-1/2 for the 1-250 MHz range.
We have also had reported wireless HDTV boxes, and FOSCAM and AMCREST security camera systems causing RFI to garage door remote openers. Use our Garage Door Opener RFI kit to suppress the interference to the opener (VICTIM) – you need one kit for each opener. Maximize the distance from the camera to the openers may also help. Additionally shield cable to the garage door sensors may be needed depending on severity of the camera RFI.
Obvious Tech Note: make sure your remote batteries have enough energy to activate the GDO or the signal they transmit may not be large enough to over ride the RFI signal, but a fresh battery may be able to overcome the weak RFI source and allow the GDO to operate correctly.