50:300 (6:1) CUBE™ Balun, 1-61 MHz, 1.5/3KW (choose top stud/eyebolt/power rating)Product DetailsMPN: CB-6-1500,CB-6-3000Input ohms/Output ohms: 50 in, 300 outFrequency Range < 2:1 SWR (MHz): 1-61PEP Power Rating (watts): 1500/3000Weight (pounds): 1500=2#, 3000=4 #1500/3000 Watt 6:1 CUBE Balun™ – Model CB-6-1500/3000
Model CB-6-1500/3000 is a 6:1 (300:50) balun housed in a NEMA enclosure box (1.5KW in 4″ x 4″ x 2″, 3KW in 6" x 6" x 4") with two top studs capable of input power levels up to 1.5KW PEP watts when used with a matched load. The 6:1 ratio takes 50 ohms input and matches to 300 ohms balanced output from 1-61 MHz with SWR < 1.5:1 under matched load conditions. A great balun for windoms, OCF antennas >60 feet over ground, Hertz and folded dipole antennas, T2FD etc. 8 core, Use “EB” version with side eye bolts for wire attachments for OCF dipole use.
Typical SWR and impedance transformation from 1-61 MHZ shown below:
This transformer requires a feed line choke to isolate the coax feed line from the antenna. A coax noise filter is also recommended.
1500/3000 Watt 6:1 CUBE Balun™ – Model CB-6-1500/3000
Model CB-6-1500/3000 is a 6:1 (300:50) balun housed in a NEMA enclosure box (1.5KW in 4″ x 4″ x 2″, 3KW in 6" x 6" x 4") with two top studs capable of input power levels up to 1.5KW PEP watts when used with a matched load. The 6:1 ratio takes 50 ohms input and matches to 300 ohms balanced output from 1-61 MHz with SWR < 1.5:1 under matched load conditions. A great balun for windoms, OCF antennas >60 feet over ground, Hertz and folded dipole antennas, T2FD etc. 8 core, Use “EB” version with side eye bolts for wire attachments for OCF dipole use.
Typical SWR and impedance transformation from 1-61 MHZ shown below:
This transformer requires a feed line choke to isolate the coax feed line from the antenna. A coax noise filter is also recommended.
Christmas lights or yard lights with switching DC power supplies are often the RFI source and a clamp on ferrite bead on the AC AND the DC side feeding the lights is needed to help suppress the switching power supply RFI noise. Suitable snap on beads are FSB31-1/2 for the 1-250 MHz range.
We have also had reported wireless HDTV boxes, and FOSCAM and AMCREST security camera systems causing RFI to garage door remote openers. Use our Garage Door Opener RFI kit to suppress the interference to the opener (VICTIM) – you need one kit for each opener. Maximize the distance from the camera to the openers may also help. Additionally shield cable to the garage door sensors may be needed depending on severity of the camera RFI.
Obvious Tech Note: make sure your remote batteries have enough energy to activate the GDO or the signal they transmit may not be large enough to over ride the RFI signal, but a fresh battery may be able to overcome the weak RFI source and allow the GDO to operate correctly.