Transceiver RFI Kits

 

Does the operation of a treadmill or your exercise equipment wipe out your radio receiver reception? We have heard cases where the treadmill from a neighbor’s house wiped out the ham radio receiver reception from 2-30 Mhz! The treadmill source was finally isolated to a variable speed motor power supply that was injecting RFI into the AC wiring of the house and the AC wiring was acting as a transmitting antenna broadcasting the signal to the entire neighborhood. The case was difficult to track down since the broadband RFI interference only occurred at 7-8 pm each nite when the neighbor used the treadmill. As with all RFI cases the sequence is similar: Find the Source, Choke the Path, Protect the Victim.

Once the source was identified, a simple solution was to choke off the transmitting antenna with a AC line choke shown below which eliminated the interference problem to the ham receiver:

Testimonials

F400-31 AC Power Cord Choke completely cured the RFI problem I had with my wife’s treadmill. Now I can hear the weak signals!

73,
Jim K4AXF
Icom IC-725
Grottoes, Shenandoah Valley, Virginia
Refine by
 

Filters

Filters

 

Also make sure you connect a good RF ground to the transceiver ground post.

Note to Flex Radio users:  Use snap on ferrites for firewire cable, speaker cable and mic cable,  Ring ferrites for Antenna output and DC power.

For additional RFI suppression, use a feed line choke at the antenna to suppress common current on the coax feed line – see our store for feed line choke alternatives for use at the antenna.

 

If you use a linear amplifier we have RFI kits for linear amplifiers that help suppress RFI in your shack or in your neighbor’s house.