MINI-BALUN 1:1 Coax Interface to Ladder Line, Dipole elements, 500 Watts PEP, up to -38Db Common Mode Rejection, 1-61 MHz, Flagpole, Dipole, Beam and G5RV/ZS6BKW Antennas

Name: MINI-BALUN 1:1 Coax Interface to Ladder Line, Dipole elements, 500 Watts PEP, up to -38Db Common Mode Rejection, 1-61 MHz, Flagpole, Dipole, Beam and G5RV/ZS6BKW Antennas
Brand: Palomar Engineers
SKU: MB-1-500SS
Price: 69.95 USD
Availability: InStock

MB-1-500SS

$69.95

In stock

Quantity:

Product Details

Brand: Palomar Engineers

MPN: MC-1-500SS

Country/Region of Manufacture: United States

Effective Frequency Range (MHz): 1.8-60

PEP Power Rating (watts): 500 SSB (25% duty cycle), 250 Watts CW/FT8 (50% duty cycle)

Common Mode Attenuation (db): 20-38db

Estimated Insertion Loss (db): .25 db

Input Connector Type: SO-239 female

Output Connector Connector Type: Dual 1/4" stainless steel studs

Ground Connector (Y/N): none

Enclosure Size (LxWxH inches): 3" long, 2 in wide, 1.25" high

MINI-BALUN Features:

- Uses proprietary Multi-Turn ferrite technology for maximum choking (up to -38 dB common mode noise rejection) and maximum bandwidth

- 500 Watts PEP, 50 ohm SO-239 connectors In, Dual Side Stud Output, 1.8-61 MHz (usable to 100 MHz) - AKA 1:1 BALUN

- Works for all coax fed antennas from 1.8-61 MHz (160-6 meters) - excellent for multi-band beam interface, G5RV/ZS6BKW or Flag Pole OCF antennas fed with ladder line.

- 2-5 times more common mode noise rejection, wider bandwidth and higher power then competing isolators

MINI-CHOKER feed line chokes are used to suppress common mode current carried on the outside of the coax braid which is often responsible for receiver noise and RFI in the receiver/transmitter. These chokes are very useful for suppressing RFI common mode current at the antenna feed point, at 1/2 wavelength intervals along the coax feed line and also at the entrance to the radio station.

This choke has a SO-239 input and 1/4" top studs output.

For Higher Power needs use our MAXI-CHOKER with dual stud outputs in 1.5KW or 3KW version part# MC-1-1500LL, MC-1-3000LL

If you need a unbalanced output (SO239 output) instead of a balanced stud output, see MC-1-500 with SO239 output and input..

Save this product for later

These RFI kits are specifically selected to cure most household computer device RFI problems. It contains ferrite toroids for AC or DC power supply protection and Snap On ferrite spli beads selected to eliminate RFI from 1 to 1000 Mhz. The beads are easy to use, don’t require modification of the protected equipment and work in almost all cases, even when plug-in filters fail.

Typical Installations


Ethernet Cable on F-240 Toroid – 7 turns	Ethernet Cable on FSB-1/2 – 3 turns for 9X Impedance	Ethernet Cable on FSB-1/4
AC Cable on F-240 Toroid – 6 turns	DSL Modem DC Power Supply on F114-43 Toroid – 5 Turns