Bullet 50:450 (9:1) HF Balun, 1.8-61 MHz, 500/1500 Watts, T2FD, BBTD, ALE

Name: Bullet 50:450 (9:1) HF Balun, 1.8-61 MHz, 500/1500 Watts, T2FD, BBTD, ALE
SKU: Bullet-9B-500EB
Price: 89.95 USD
Availability: InStock

Bullet-9B-500EB

$89.95

In stock

Quantity:

Product Details

Country/Region of Manufacture: USA

Type: NEW

Input ohms/Output ohms: 50 in, 450 out

Frequency Range < 2:1 SWR (MHz): 1.8-61

PEP Power Rating (watts): 500/1500

Transformer Topology: Braodband Ferrite

Hardware Type: Stainless Steel

Weight (pounds): 2

Antenna Compatability: T2FD, BBTD, ALE, Rhombic

The Bullet-9B is a multi-core balun with a compact enclosure (looks like a bullet) enclosure that is lightweight and easy to transport for your fixed/portable ALE, T2FD or BBTD antenna systems. Also useful for rhombics and other wire antennas needing balanced 450 ohm output. Halyard hoist at top of balun for convenient attachment point. Input is via SO-239 coax connector and output with side eye bolt output.Use a 500 ohm non-inductive termination resistor for the T2FD when using this balun.

This transformer requires a feed line choke to isolate the coax feed line from the antenna. A coax noise filter at the radio end of the coax is also recommended to reduce common mode noise current picked up by the coax braid.

Available in 500 watts and 1500 watt models

Remember we over engineer our products, to out perform our competition - just compare the weight of our baluns to theirs and you will know we put much more into our products so you don't have to worry about failure at a critical moment.

Save this product for later

These RFI kits are specifically selected to cure most household computer device RFI problems. It contains ferrite toroids for AC or DC power supply protection and Snap On ferrite spli beads selected to eliminate RFI from 1 to 1000 Mhz. The beads are easy to use, don’t require modification of the protected equipment and work in almost all cases, even when plug-in filters fail.

Typical Installations


Ethernet Cable on F-240 Toroid – 7 turns	Ethernet Cable on FSB-1/2 – 3 turns for 9X Impedance	Ethernet Cable on FSB-1/4
AC Cable on F-240 Toroid – 6 turns	DSL Modem DC Power Supply on F114-43 Toroid – 5 Turns